Honda CR-V: Driver’s Seat Power Adjustments
EX-L and Canadian EX models
See pages for important safety
information and warnings about how to
properly position the seats and seatbacks.
The controls for the power
adjustable driver’s seat are on the
outside edge of the seat bottom. You
can adjust the seat with the ignition
switch in any position. Make all seat
adjustments before you start driving.
The front passenger’s seat can be
adjusted manually (see the next
page).


Moves the seat forward
and backward.

Moves the front of the
seat up or down.

Raises or lowers the seat.

Moves the whole seat up
and forward, or down
and backward. The front
of the seat also tilts up or
down at the same time.

Adjusts the seat-back
angle forward or
backward.

Increases or decreases
the lumbar support.
READ NEXT:
LX and U.S. EX models
See pages for important safety
information and warnings about how to
properly position the seats and seatbacks.
Make all seat adjustments before
you start driving.
T
To adjust the seats forward and
backward, pull up on the lever under
the seat cushion. After moving the
seat, make sure it is locked into
position.
The angle of each rear seat-back can
Each front seat has an armrest on
the side of the seat-back. To use it,
pivot it down.
The rear seat armrest is in the
center of the rear seat. Pivot it down
to use it.
SEE MORE:
NOTE:
Before you troubleshoot, record all freeze data and
any on-board snapshot, and review the general
troubleshooting information.
If DTC P1128, P1129, P2228, and/or P2229 are stored
at the same time as DTC P0101, troubleshoot those
DTCs first, then recheck for DTC P0101.
1. Check for poor
1. Turn the ignition switch ON (II).
2. Clear the DTC with the HDS.
3. Test-drive the vehicle. Drive the vehicle at 10 mph
(15 km/h) or more, with the engine speed at
2,500 rpm or more.
4. Check for DTCs with the HDS.
Is DTC 51 indicated?
YES-Replace the VSA modulator-control unit.
NO-Intermitt
© 2016-2025 Copyright www.hcrv.net
