Honda CR-V: Soft-Keys
Soft-Keys are accessible on the Uconnect display.
Customer Programmable Features - Uconnect 5.0/8.4 Settings
Uconnect 5.0 - Press the SETTINGS hard-key to display the menu setting screen. Uconnect 8.4-Touch the "Apps" soft-key, then touch the "Settings" soft-key to display the menu setting screen. In this mode the Uconnect system allows you to access programmable features that may be equipped such as Display, Clock, Safety/Assistance, Lights, Doors & Locks, Auto-On Comfort & Remote Start, Engine Off Operation, Compass Settings, Audio, Phone/Bluetooth and SiriusXM Setup.
NOTE: Only one touchscreen area may be selected at a time.
When making a selection, touch the soft-key to enter the desired mode. Once in the desired mode, touch and release the preferred setting until a check-mark appears next to the setting, showing that setting has been selected.
Once the setting is complete, either touch the back arrow soft-key or the Back hard-key to return to the previous menu or touch the "X" soft-key to close out of the settings screen. Touching the Up or Down Arrow soft-keys on the right side of the screen will allow you to toggle up or down through the available settings.
READ NEXT:
Soft-Keys - Display
After pressing the "Display" soft-key the following settings
will be available.
Display Mode
When in this display you may select one of the auto
display settings. To change Mode status, touch and
r
Soft-Keys - Safety & Driving Assistance
After pressing the "Safety & Driving Assistance" soft-key
the following settings will be available.
Park Assist
The Rear Park Assist system will scan for objects behind
the vehicle when the tra
Soft-Keys - Lights
After pressing the Lights soft-key the following settings
will be available.
Headlight Off Delay
When this feature is selected, the driver can choose to
have the headlights remain on for 0, 30, 60,
SEE MORE:
General Troubleshooting Information
Intermittent Failures
The term "intermittent failure" means a system may
have had a failure, but it checks OK now. If the
malfunction indicator lamp (MIL) on the dash does not
come on, check for poor connections or loose pins at all
connectors related to the circuit that you are
troubleshooting. If
DTC Troubleshooting
DTC P0506: Idle Control System RPM Lower
Than Expected
NOTE: Before you troubleshoot, record all freeze data
and any on-board snapshot, and review the general
troubleshooting information.
1. Turn the ignition switch ON (II).
2. Clear the DTC with the HDS.
3. Start the engine. Hold the engine speed
