Honda CR-V manuals

Honda CR-V: Replacing Rear Bulbs

Honda CR-V (2006–2011) Owner's Manual / Maintenance / Lights / Replacing Rear Bulbs

1. Open the tailgate. Place a cloth on

1. Open the tailgate. Place a cloth on the edge of the cover to prevent scratches. Remove the covers by carefully prying on the edge with a small flat-tip screwdriver.

2. Use a Phillips-head screwdriver to

2. Use a Phillips-head screwdriver to remove the taillight assembly mounting screw under each cover.

3. Pull the taillight assembly out of the rear pillar.

4. Determine which of the four bulbs

4. Determine which of the four bulbs is burned out: stop/taillight, backup light, turn signal, or side marker.

5. Remove the socket by turning it one-quarter turn counterclockwise.

6. Pull the bulb straight out of its socket. Push the new bulb straight into the socket until it bottoms.

7. Reinstall the socket into the light assembly by turning it clockwise until it locks.

8. Turn on the lights to make sure the new bulb is working.

9. Align the clips on the taillight assembly with the holes in the body, then push the taillight assembly into place. Tighten the two mounting screws securely and reinstall the covers.

READ NEXT:

 Replacing a High-mount Brake Light Bulb

1. Open the tailgate. Unlatch the top of the cover by pulling back on it with your hands. 2. Place a cloth on the side edge of the cover to prevent scratches. Remove the cover by carefully

 Cleaning the Seat Belts

Dirt build-up in the loops of the seat belt anchors can cause the belts to retract slowly. Wipe the insides of the loops with a clean cloth dampened in mild soap and warm water or isopropy

 Floor Mats

The floor mats that came with your vehicle hook over the floor mat anchors. This keeps the floor mats from sliding forward, possibly interfering with the pedals, or backwards, making the f

SEE MORE:

 ATF Cooler

ATF Cooler Cleaning Special Tools Required ATF cooler cleaner GHTTTCF6H Magnetic nonbypass spin-on filter GTHGNBP2 These special tools are available through the Honda Tool and Equipment Program 1-888-424-6857. Before installing an overhauled or remanufactured automatic transmission, you must

 Turn Signal/Hazard Flasher

Component Location Index TURN SIGNAL SWITCH (Built into the combination light switch) TURN SIGNAL INDICATORS HAZARD WARNING SWITCH MICU (Built into the under-dash fuse/relay box) Circuit Diagram MICU Input Test NOTE: Before testing, troubleshoot the B-CAN System Diagnosis Test Mode A. 1.

© 2016-2025 Copyright www.hcrv.net