Honda CR-V: Seat Heaters
Component Location Index

- DRIVER'S SEAT
HEATER RELAY (HIGH)
- DRIVER'S SEAT
HEATER RELAY (LOW)
- DRIVER'S SEAT CUSHION HEATER
- DRIVER'S SEAT-BACK HEATER
- FRONT PASSENGER'S
SEAT-BACK HEATER
- FRONT PASSENGER'S
SEAT CUSHION HEATER
- FRONT PASSENGER'S SEAT
HEATER RELAY (HIGH)
- FRONT PASSENGER'S SEAT
HEATER RELAY (LOW)

- DRIVER'S SEAT HEATER SWITCH
- FRONT PASSENGER'S
SEAT HEATER SWITCH
Circuit Diagram


Seat Heater Test
1. Remove the driver's or front passenger's seat.
2. Disconnect the 3P (A) and 2P (B) connectors from
the seat heater.
Driver's Seat

Front Passenger's Seat

3. Check for continuity between the seat heater
connector B (2P) No.1 and No.2 terminals. There
should be continuity.
4. Reconnect the seat heater connector B (2P) to the
seat-back heater.
5. Check for continuity between the seat heater
connector A (3P) No.1 and No.2 terminals, No.2
and No.3 terminals, and No.1 and No.3 terminals.
There should be continuity.
6. If the continuity is not as specified, replace the
appropriate seat heater.
Switch Test/Replacement
1. Remove the shift lever panel.
2. Disconnect the 6P (or 7P) connector from the seat
heater switch (A), then remove the switch.
* : Front passenger's

3. Check for continuity between the terminals in each
switch position according to the table.

: Front
passenger's seat heater switch
4. If the continuity is not as specified, replace the
switch.
READ NEXT:
Component Location Index
UNDER-DASH FUSE/
RELAY BOX
UNDER-HOOD FUSE/RELAY BOX
REAR WINDOW DEFOGGER RELAY
HVAC CONTROL UNIT
REAR WINDOW DEFOGGER SWITCH/
MIRROR DEFOGGER SWITCH
REAR WINDOW DEF
Component Location Index
IMMOBILIZER INDICATOR
IMMOBILIZER-KEYLESS CONTROL UNIT (Built-in receiver)
UNDER-DASH
FUSE/RELAY BOX
IMOES UNIT
(Built into the MICU)
PCM
IGNITION KEY
TRANSPONDE
SEE MORE:
If equipped
On U.S. model is shown
Do not put any items on the dual
deck cargo shelf that could block
your view or be thrown around the
vehicle during a crash.
Do not use the dual deck cargo shelf
if the rear seats are folded down.
Do not exceed the dual deck cargo
shelf load limit o
1. Open the hood.
To change the parking light/front
side marker on the driver’s side,
remove the fuse box fromits stay
by pulling out.
2. Remove the socket from the
headlight assembly by turning it
one-quarter turn counterclockwise.
3. Pull the bulb straight out of its
socket. P
© 2016-2025 Copyright www.hcrv.net
