Honda CR-V: Jump Starting

Although this seems like a simple procedure, you should take several precautions.

A battery can explode if you do

A battery can explode if you do not follow the correct procedure, seriously injuring anyone nearby.

Keep all sparks, open flames, and smoking materials away from the battery.

You cannot start your vehicle by pushing or pulling it.

To Jump Start Your Vehicle:

1. Open the hood, and check the physical condition of the battery.

In very cold weather, check the condition of the electrolyte. If it seems slushy or frozen, do not try jump starting until it thaws.

If a battery sits in extreme cold, the

If a battery sits in extreme cold, the electrolyte inside can f reeze.

Attempting to jump start with a f rozen battery can cause it to rupture.

2. Put the transmission in Park, and set the parking brake.

Turn off all the electrical accessories:

heater, A/C, climate control, audio system, lights, etc.

The numbers in the illustration show

The numbers in the illustration show you the order to connect the jumper cables.

3. Connect one jumper cable to the positive ( + ) terminal on your battery. Connect the other end to the positive ( + ) terminal on the booster battery.

4. Connect the second jumper cable

4. Connect the second jumper cable to the negative ( - ) terminal on the booster battery. Connect the other end to the stud bolt on the engine side as shown. Do not connect this jumper cable to any other part of the engine.

5. If the booster battery is in another vehicle, have an assistant start that vehicle and run it at a fast idle.

6. Start your vehicle. If the starter motor still operates slowly, check that the jumper cables have good metal-to-metal contact.

7. Once your vehicle is running, disconnect the negative cable from your vehicle, then from the booster battery. Disconnect the positive cable from your vehicle, then from the booster battery.

Keep the ends of the jumper cables away from each other and any metal on the vehicle until everything is disconnected. Otherwise, you may cause an electrical short.

READ NEXT:

 If the Engine Overheats

The reading of the vehicle’s temperature gauge should stay in the midrange. If it climbs to the red mark, you should determine the reason (hot day, driving up a steep hill, etc.). If the

 Low Oil Pressure Indicator

Low Oil Pressure Indicator This indicator should never come on when the engine is running. If it starts flashing or stays on, the oil pressure has dropped very low or lost pressure. Serio

 Charging System Indicator

If the charging system indicator comes on brightly when the engine is running, the battery is not being charged. Immediately turn off all electrical accessories. Try not to use other elec

SEE MORE:

 Protecting Infants

Child Seat Type An infant must be properly restrained in a rear-facing, reclining child seat until the child reaches the seat maker’s weight or height limit for the seat, and the child is at least one year old. Only a rear-facing child seat provides proper support for a baby’s

 DTC 51: Motor Locked

1. Turn the ignition switch ON (II). 2. Clear the DTC with the HDS. 3. Test-drive the vehicle. Drive the vehicle at 10 mph (15 km/h) or more, with the engine speed at 2,500 rpm or more. 4. Check for DTCs with the HDS. Is DTC 51 indicated? YES-Replace the VSA modulator-control unit. NO-Intermitt

© 2016-2025 Copyright www.hcrv.net