Honda CR-V: Door Lower Trim Replacement

NOTE:

1. Remove these items:

2. From the front or the rear door, remove the screw.

Honda CR-V. Exterior Trim

3. Using a utility knife, carefully cut the double-sided adhesive tape (A) along the edge of the door lower trim (B).

Front door

Honda CR-V. Exterior Trim

Rear door

Honda CR-V. Exterior Trim

4. With the help of an assistant, slide the door lower trim (A) rearward, and remove it. The clips (B, C) stay in the body. Turn the clips (B) 45 º counterclockwise, and remove them.

Front door

Honda CR-V. Exterior Trim

Rear door

Honda CR-V. Exterior Trim

5. Check if the clips are damaged or stress-whitened, and if necessary, replace them with new ones.

6. Install the clips on the trim.

7. Scrape off the remaining double-sided adhesive tape from the trim and door, then clean the trim and door surfaces with a sponge dampened in isopropyl alcohol.

8. Apply primer to the area where the panel will be applied.

9. Attach the double-sided adhesive tape (A) to the trim (B), and fold the edge of each adhesive backing from the double-sided adhesive tape.

Front door

Honda CR-V. Exterior Trim

Rear door

Honda CR-V. Exterior Trim

10. Hold the trim (A) up, and fit all the clips (B, C) into the holes in the door, then push on the trim until the clips snap into place.

Front door

Honda CR-V. Exterior Trim

Rear door

Honda CR-V. Exterior Trim

11. Carefully pull the adhesive backing (D) away, and push the trim into place securely.

12. Set the screw into the back of clip, then reinstall the door speaker and the door panel.

READ NEXT:

 Side Windshield Trim Replacement

Special Tools Required KTC trim tool set SOJATP2014 * * Available through the American Honda Tool and Equipment Program; call 888-424-6857 NOTE: Put on gloves to protect your hands. Take care not t

 Fenderwell

Front Inner Fender Replacement NOTE: Take care not to scratch the body. 1. Remove the front wheel arch protector, as needed. 2. Remove the front inner fender (A). Remove the screws (B, C), and remo

 Openers

Component Location Index HOOD OPENER CABLE Replacement FUEL FILL DOOR OPENER Replacement TAILGATE LATCH Replacement FUEL FILL DOOR LATCH Replacement FUEL FILL DOOR OPENE

SEE MORE:

 To Load a Disc

The in-dash disc player is behind the navigation screen. To use the disc player, press the OPEN button beside the screen. The screen folds back, and the disc slot appears. Insert a disc about halfway into the disc slot. The drive will pull the disc in the rest of the way and beg

 DTC P0731: Problem in 1st Clutch and 1st Clutch Hydraulic Circuit

NOTE: Before you troubleshoot, record all freeze data and any on-board snapshot, and review General Troubleshooting Information. 1. Warm up the engine to normal operating temperature (the radiator fan comes on). 2. Make sure that the transmission is filled to the proper level, and check for fluid

© 2016-2025 Copyright www.hcrv.net