Honda CR-V: Relay and Control Unit
Locations
Engine Compartment

- VSA MODULATOR-CONTROL UNIT
- AUXILIARY UNDER-HOOD
RELAY BOX
- POWER MIRROR
DEFOGGER RELAY
- PCM
- RADIATOR FAN RELAY
- ELECTRONIC THROTTLE CONTROL SYSTEM (ETCS) CONTROL RELAY
- ELD UNIT
- PGM-FI MAIN RELAY 1 (FI MAIN)
- UNDER-HOOD FUSE/RELAY BOX
- FAN CONTROL RELAY
- BLOWER MOTOR RELAY
- REAR WINDOW WIPER MOTOR
RELAY
- PGM-FI SUBRELAY
- REAR WINDOW DEFOGGER RELAY
- IGNITION COIL RELAY
- A/C COMPRESSOR CLUTCH RELAY
Dashboard

- GAUGE CONTROL MODULE
- XM RECEIVER
(With XM radio)

- CARGO AREA ACCESSORY POWER
SOCKET RELAY
- CONSOLE ACCESSORY POWER
SOCKET RELAY
- FRONT ACCESSORY POWER
SOCKET RELAY
- TPMS CONTROL UNIT

- NAVIGATION DISPLAY UNIT
or AUDIO UNIT (Without navigation system)
- IMMOBILIZER-KEYLESS
CONTROL UNIT
(Built-in receiver)
- HVAC CONTROL UNIT
- SRS UNIT
Driver's Door

- POWER WINDOW MASTER SWITCH
(Has built-in control unit)
- MOONROOF CONTROL
UNIT/MOTOR
Seat

- DRIVER'S SEAT
- DRIVER'S SEAT HEATER
HIGH RELAY (4P)
DRIVER'S SEAT HEATER
LOW RELAY (5P)
- FRONT PASSENGER'S SEAT
- FRONT PASSENGER'S SEAT
HEATER HIGH RELAY (4P)
FRONT PASSENGER'S SEAT
HEATER LOW RELAY (5P)
READ NEXT:
Connector Index
Identification numbers have been assigned to in-line connectors, junction
connectors, and terminals. The number is preceded by the letter ºC" for
connectors "G" for ground terminals
Under-hood Fuse/Relay Box
Removal and Installation
Removal
1. Make sure you have the anti-theft codes for the
audio and navigation system. If equipped with XM
radio, write down the XM radio presets.
WARNING
A battery can explode if you do not follow the
proper procedure, causing serious injury to anyone
nearby. Follow all procedures carefully and keep
sparks and open flames away from the battery.
SEE MORE:
1. Open the hood.
To change the parking light/front
side marker on the driver’s side,
remove the fuse box fromits stay
by pulling out.
2. Remove the socket from the
headlight assembly by turning it
one-quarter turn counterclockwise.
3. Pull the bulb straight out of its
socket. P
NOTE: Before you troubleshoot, record all freeze data and any on-board
snapshot, and review General Troubleshooting Information.
1. Warm up the engine to normal operating
temperature (the radiator fan comes on).
2. Make sure that the transmission is filled to the
proper level, and check for fluid
© 2016-2025 Copyright www.hcrv.net
