Honda CR-V: Starting the Engine
1. Apply the parking brake.
2. In cold weather, turn off all electrical accessories to reduce the drain on the battery.
3. Make sure the shift lever is in Park. Press on the brake pedal.
4. Without touching the accelerator pedal, turn the ignition key to the START (III) position. Do not hold the key in the START (III) position for more than 15 seconds at a time. If the engine does not start right away, pause for at least 10 seconds before trying again.
The immobilizer system protects your vehicle f rom thef t. If an improperlycoded key (or other device) is used, the engine’s f uel system is disabled. For more inf ormation.
The engine is harder to start in cold weather. Also, the thinner air f ound at altitudes above 8,000 f eet (2,400 meters) adds to this problem.
READ NEXT:
Shift Lever Position Indicators
These indicators on the instrument
panel show which position the shift
lever is in.
The ‘‘D’’ indicator comes on for a
few seconds when you turn the
ignition switch to the ON (II)
Shifting
To shift from any position, press
firmly on the brake pedal and the
release button on the side of the
shift lever. You cannot shift out of
Park when the ignition switch is in
the LOCK (0)
SEE MORE:
DTC P2227: BARD Sensor Range/Performance Problem
NOTE:
Before you troubleshoot, record all freeze data and any on-board
snapshot, and review the general troubleshooting information.
If DTC P0101, P0108, P1128, and/or P1129 are stored
at the same time as DTC P2221, troubleshoot those
DTCs first, then recheck for DTC P2221.
1. Turn the ignit
DTC P0128: Cooling System Malfunction
NOTE: Before you troubleshoot, record all freeze data
and any on-board snapshot, and review the general
troubleshooting information.
1. Turn the ignition switch ON (II).
2. Clear the DTC with the HDS.
3. Turn the blower switch OFF.
4. Check the FAN CTRL in the DATA LIST with the
HDS.
Is it OFF?
