Honda CR-V: Accessory Power Sockets

Your vehicle has two or three

Your vehicle has two or three accessory power sockets depending on the model.

To use an accessory power socket,

To use an accessory power socket, the ignition switch must be in the ACCESSORY (I) or ON (II) position.

Each socket is intended to supply power for 12 volt DC accessories that are rated 120 watts or less (10 amps).

None of the sockets will power an

None of the sockets will power an automotive type cigarette lighter element.

Make sure to put the socket cover

Make sure to put the socket cover back in place to prevent any small foreign objects from getting into the socket.

READ NEXT:

 Console Compartment

EX-L model Push the release knob to open or close the console compartment, slide the lid rearward.

 Coat Hook

To use a coat hook, slide it out slightly, then pull it down. Make sure the coat hook is folded up when you are not using it. This hook is not designed for large or heavy items.

 Seat Under Tray

If equipped Your vehicle has a seat under tray located under the front passenger seat. Use the tray by pulling on the front center edge of the tray.

SEE MORE:

 Power Mirrors

Component Location Index POWER MIRRORS/POWER MIRROR DEFOGGERS AUXILIARY UNDER-HOOD RELAY BOX POWER MIRROR DEFOGGER RELAY REAR WINDOW DEFOGGER SWITCH/ MIRROR DEFOGGER SWITCH POWER MIRROR SWITCH Circuit Diagram Function Test 1. Remove the power mirror switch. 2. Disconnect the 13P co

 No sound is heard from speaker(s) (display is normal) (with navigation)

NOTE: Set the fader and balance positions to the center. Before doing symptom troubleshooting, do the power switch will not turn ON troubleshooting. 1. Check that the volume button is not set to the MIN level. Is it at MIN level? YES-Raise the volume level, and recheck the function. NO-Go to

© 2016-2025 Copyright www.hcrv.net