Honda CR-V: Differential Disassembly
Special Tools Required
- Holder handle 07JAB-001020A
- Companion flange holder 07RAB-TB4010B
1. Remove the drain plug (A) and the oil filler plug (B) with sealing washers (C).
2. Raise the locknut tab (A) from the groove of the clutch guide, making sure the tab completely clears the groove to prevent damaging the clutch guide.
3. Install the companion flange holder (A) and holder handle (B) on the companion flange.
4. Loosen the locknut (A) counterclockwise so its tab (B) comes out from the groove (C) in the clutch guide.
Torque: 147 N.m (15.0 kgf.m, 108 Ibf*ft)
5. Tighten the locknut (A) until its tab (B) aligns with the groove (C).
6. Remove any dirt from inside the groove in the clutch guide, then loosen the locknut.
7. Remove the locknut (A), the disc spring washer (B), the back-up ring (C), the O-ring (D), and the companion flange (E).
8. Remove the eight mounting bolts (A) in a crisscross pattern in several steps, then remove the torque control differential case (B) and the dowel pins (C).
9. Remove the shim (A) and the clutch assembly (B).
10. Remove the six steel balls (A), the base cam (B), the thrust needle bearings (C), and the pressure plate (D).
NOTE: Do not lose the steel balls.
11. Remove the oil pump drives haft.
12. Remove the oil pump body assembly (A), the oil pump pin (B), the dowel pins (C), the magnet (D), and the ATF strainer (E).
READ NEXT:
Differential Reassembly
Exploded View
Special Tools Required
Holder handle 07JAB-001020A
Companion flange holder 07RAB-TB4010B
1. Apply differential fluid to the rubber pinion of the
ATF strainer (A), then install the A
Differential Mount Replacement
Exploded View
Differential Installation
1. Install rear differential mount assembly A to the
rear differential assembly (B).
2. Jack up the rear differential.
3. Install the new set rings (A) onto t
Driveline/Axle
Special Tools
Oil Seal Driver
Attachment, 52 x 55 mm
Half Shaft Base
Threaded Adapter, 24 x 1.5 mm
Threaded Adapter, 26 x 1.5 mm
Attachment, 35 mm I.D.
Driver
Inner Handle, 30 mm
Oil Seal
SEE MORE:
A/C Signal Circuit Troubleshooting
1. Start the engine, and let it idle.
2. Turn the blower switch on.
3. Turn the A/C switch on.
4. Check the A/C CLUTCH in the DATA LIST with the
HDS.
Does it indicate ON?
YES-Go to step 5.
5. Check the A/C system.
Does the A/C system operate? YES-The air conditioning system circuit is OK.
NO-Go t
DTC Troubleshooting
DTC 11, 13, 15, 17: Low Tire Pressure
NOTE: If low tire pressure is detected, the control unit
sets one or more of these DTCs, and turns on the low
pressure indicator. If the low pressure indicator comes
on due to true low tire pressure, and the customer
corrects it before bringing the vehicle in, t
