Honda CR-V: Vanity Mirror

To use the vanity mirror on the back

To use the vanity mirror on the back of the sun visor, pull up the cover.

Except LX model

The vanity mirror lights come on when you pull up the cover.

READ NEXT:

 Sun Visor

To use the sun visor, pull it down. When using the sun visor for the side window, remove the support rod from the clip, and swing it out. Make sure you put the sun visor back in place when

 Sunglasses Holder

To open the sunglasses holder, push then release the raised detent. It will unlatch and swing down. To close it, push it until it latches. Make sure the holder is closed while you are driv

 ConversationMirror

The sunglasses holder uses a convex mirror for its bottom panel. You can see all the vehicle passengers in this mirror. To use the mirror, open the sunglasses holder fully, push it to the

SEE MORE:

 Lower Ball Joint Replacement

Special Tools Required Ball joint remover, 32 mm 07MAC-SL0A 102 Ball joint thread protector, 14 mm 071AF-S3VA000 1. Remove the front wheel. 2. Remove the flange bolt and flange nuts from the lower arm (A). NOTE: During installation, install a new flange bolt and new flange nuts. After lightly

 Horns

Component Location Index HORN HORN SWITCH HORN RELAY CIRCUIT (Built into the MICU) CABLE REEL UNDER-DASH FUSE/RELAY BOX Circuit Diagram Horn Switch Test 1. Remove the steering column covers. 2. Disconnect the dashboard wire harness 20P connector (A) from the cable reel (B). 3. Usin

© 2016-2025 Copyright www.hcrv.net