Honda CR-V: Replacing a High-mount Brake Light Bulb

1. Open the tailgate.
Unlatch the top of the cover by
pulling back on it with your hands.

2. Place a cloth on the side edge of
the cover to prevent scratches.
Remove the cover by carefully
prying on the edge with a small
flat-tip screwdriver and pulling the
cover off.
3. Remove the socket from the light
assembly by turning it one-quarter
turn counterclockwise.

4. Pull the bulb straight out of its
socket. Push the new bulb straight
into the socket until it bottoms.
5. Press the brake pedal to make
sure the new bulb is working.
6. Put the socket back into the light
assembly, and turn it clockwise to
lock it in place.
7. Put the cover back on the light
assembly. Push it in until it locks
in place.
READ NEXT:
Dirt build-up in the loops of the seat
belt anchors can cause the belts to
retract slowly. Wipe the insides of
the loops with a clean cloth
dampened in mild soap and warm
water or isopropy
The floor mats that came with your
vehicle hook over the floor mat
anchors. This keeps the floor mats
from sliding forward, possibly
interfering with the pedals, or
backwards, making the f
Your vehicle is equipped with an
antenna at the rear of the roof . Bef ore
using a ‘‘drive-through’’ car wash,
remove the antenna by unscrewing it by
hand. This prevents the antenna
SEE MORE:
Exploded View
Special Tools Required
Cylinder end seal remover attachment
070AF-S7S0100
Valve seal ring sizing tool 07NAG-SR3090A
Sleeve seal ring guide 07YAG-S2X0100
Sleeve seal ring sizing tool, 36 mm 07ZAG-S5A0100
Attachment, 28 x 30 mm 07946-1870100
Driver 07749-0010000
Piston seal ri
Upper Front Grille Replacement
NOTE: Take care not to scratch the bumper and grille.
1. Remove the front bumper.
2. Remove the clips from the back of the front grille
and release the hooks (A), then release the hooks
(B) and remove the upper front grille (C) from the
lower front grille (D).
3. Re
© 2016-2025 Copyright www.hcrv.net
