Honda CR-V: Automatic Seat Belt Tensioners

For added protection, the front seat

For added protection, the front seat belts are equipped with automatic seat belt tensioners. When activated, the tensioners immediately tighten the belts to help hold the driver and a front passenger in position.

The tensioners are designed to activate in any collision severe enough to cause the front airbags to deploy, or if a sensor detects your vehicle is about to roll over.

The tensioners can also be activated during a collision in which the front airbags do not deploy. In this case, the airbags would not be needed, but the extra tension in the seat belt could be helpful.

When the tensioners are activated, the seat belts will remain tight until they are unbuckled.

READ NEXT:

 Seat Belt Maintenance

For safety, you should check the condition of your seat belts regularly. Pull each belt out fully, and look for frays, cuts, burns, and wear. Check that the latches work smoothly and the belt

 Additional Information About Your Airbags

 Airbag System Components

Airbag System Components Your airbag system includes: Two SRS (supplemental restraint system) front airbags. The driver’s airbag is stored in the center of the steering wheel; the fr

SEE MORE:

 Steering Wheel

Steering Wheel Removal SRS components are located in this area. Review the SRS component locations and the precautions and procedures before doing repairs or service. 1. Make sure you have the anti-theft code for the audio and the navigation system (if equipped), then write down the XM audio preset

 Idle Control System

Component Location Index POWER STEERING PRESSURE (PSP) SWITCH Signal Circuit Troubleshooting A/C COMPRESSOR CLUTCH RELAY (RELAY SOCKET A) Signal Circuit Troubleshooting POWERTRAIN CONTROL MODULE (PCM) General Troubleshooting Information Replacement A/C

© 2016-2025 Copyright www.hcrv.net