Honda CR-V: Side Engine Mount Bracket Replacement

1. Support the engine with a jack and wood block under the oil pan.

2. Remove the upper torque rod.

Honda CR-V. Side Engine Mount Bracket Replacement

3. Remove the ground cable (A), then remove the side engine mount bracket (B).

Honda CR-V. Side Engine Mount Bracket Replacement

4. Install the side engine mount bracket, then loosely tighten the new bolt and nut (C), and loosely tighten the bolt (D).

5. Install the ground cable.

6. Remove the air cleaner housing assembly.

7. Loosen the transmission mounting bolt and nuts (A).

Honda CR-V. Side Engine Mount Bracket Replacement

8. Raise the lift to full height.

9. Loosen the lower torque rod mounting bolt (A).

Honda CR-V. Side Engine Mount Bracket Replacement

10. Lower the vehicle on the lift.

11. Tighten the side engine mount mounting bolts and nut.

Honda CR-V. Side Engine Mount Bracket Replacement

12. Tighten the transmission mounting bolt and nuts.

Honda CR-V. Side Engine Mount Bracket Replacement

13. Raise the lift to full height.

14. Tighten the lower torque rod mounting bolt.

Honda CR-V. Side Engine Mount Bracket Replacement

15. Lower the vehicle on the lift.

16. Install the air cleaner housing assembly.

17. Install the upper torque rod, then tighten the new upper torque rod mounting bolts in the numbered sequence shown.

Honda CR-V. Side Engine Mount Bracket Replacement

 

Engine Assembly

Special Tools

Honda CR-V. Special Tools

Honda CR-V. Special Tools

READ NEXT:

 Cylinder Head

Special Tools Air Pressure Regulator Valve Guide Reamer, 5.5 mm Socket, 19 mm Holder Handle Adjuster Locknut Wrench Stem Seal Driver VTEC Air Adapter VTEC Air Stopper Air Joint Adapter C

 Engine Compression Inspection

NOTE: After this inspection, you must reset the powertrain control module (PCM), otherwise the PCM will continue to stop the injectors from functioning. Select PCM reset using the Honda Diagnostic Sy

 Valve Clearance Adjustment

Special Tools Required Adjuster 07MAA-PR70110 Locknut wrench 07MAA-PR70120 NOTE: Adjust the valves only when the cylinder head temperature is less than 100 ºF (38 ºC). 1. Remove the cylinder hea

SEE MORE:

 Towing Your Vehicle Behind a Motorhome

Your vehicle can be towed behind a motorhome at legal highway speeds up to 65 mph (100 km/h). Do not exceed 65 mph (100 km/h). Otherwise, severe transmission damage will occur. To avoid damage to the 4WD system, your vehicle must be towed with all four wheels on the ground (flat towin

 Braking System

Your vehicle is equipped with disc brakes at all four wheels. A power assist helps reduce the effort needed on the brake pedal. The anti-lock brake system (ABS) helps you retain steering control when braking very hard. Resting your foot on the pedal keeps the brakes applied lightly, b

© 2016-2025 Copyright www.hcrv.net