Honda CR-V: Instrument Panel Brightness
Honda CR-V (2006–2011) Owner's Manual / Instruments and Controls / Instrument Panel Brightness
You can change the instrument panel brightness only when the light switch is on.
Turn the knob on the lower part of the instrument panel to adjust the brightness.
You will hear a beep when maximum or minimum brightness is reached.
To reduce glare at night, the
instrument panel illumination dims
when you turn the light switch to
or 
.
Turning the select/
reset knob fully to the right until you
hear a beep will cancel the reduced
brightness.
READ NEXT:
HazardWarning Button
Push the button between the center
vents to turn on the hazard warning
lights (four-way flashers). This
causes all four outside turn signals
and both indicators in the instrument
panel t
Rear Window Defogger
The rear window defogger will clear
fog, frost, and thin ice from the
window. Push the defogger button to
turn it on and off. The indicator in
the button comes on to show the
defogger is
Parking Brake
To apply the parking brake, push the
pedal down with your foot. To
release it, push on the pedal again.
The parking brake indicator on the
instrument panel should go out when
the parking
SEE MORE:
To Play a Disc (In-dash single player)
You operate the in-dash disc player
with the same controls used for the
radio. To load or play discs, the
ignition switch must be in the
ACCESSORY (I) or ON (II) position.
Your vehicle also has a CD changer
that operates with the same
functions as the in-dash disc player.
Do not us
MICU Input Test
1. Before testing, troubleshoot the B-CAN System Diagnosis Test Mode A, and
check the No.8
(10 A), No. 10 (7.5 A), and No. 38 (30 A) fuses in the under-dash fuse/relay
box.
2. Disconnect under-dash fuse/relay box connectors E, F, S, and T.
NOTE: All connector views are wire side of female termin
© 2016-2025 Copyright www.hcrv.net
