Honda CR-V: Hood

Hood Adjustment

1. Remove these items:

2. Slightly loosen each bolt (A).

Honda CR-V. Hood

3. Adjust the hood alignment in this sequence:

4. Adjust the hood latch (D) to obtain the proper height at the forward edge, and move the hood latch right or left until the striker (E) is centered in the hood latch.

5. Tighten the bolts to the specified torque.

6. Check that the hood opens properly and closes securely.

7. Apply touch-up paint to the hinge mounting bolts and around the hinges, and let the paint dry.

8. Apply multipurpose grease to the hood latch and hood hinges as indicated by the arrows.

Honda CR-V. Hood

9. Reinstall all of the removed parts.

Hood Seal Replacement

1. Using a clip remover, detach the clips (A, B), then remove the hood seals (C, D). Take care not to scratch the hood.

Honda CR-V. Hood

2. Install the seals in the reverse order of removal, and note these items:

Hood Insulator Replacement

1. Using a clip remover, detach the clips. Release the hooks (A), then remove the hood insulator (B). Take care not to scratch the hood.

Honda CR-V. Hood

2. Install the insulator in the reverse order of removal, and note these items:

READ NEXT:

 Tailgate

Tailgate Adjustment NOTE: Have an assistant help you when adjusting the tailgate. Take care not to scratch the tailgate, body, and other related parts. Put on gloves to protect your hands. 1. R

 Fuel Fill Door

Fuel Fill Door Adjustment 1. Remove the nut (A), then remove the open spring (B). 2. Slightly loosen the hinge mounting bolts (A). 3. Adjust the fuel fill door (B) in or out until it's flush with th

 Exterior Trim

SEE MORE:

 Ignition Switch

The ignition switch has four positions: LOCK (0), ACCESSORY (I), ON (II), and START (III). LOCK (0) - You can insert or remove the key only in this position. To turn the key, the shift lever must be in Park, and you must push the key in slightly. If the front wheels are turned, the

 DTC P2227: BARD Sensor Range/Performance Problem

NOTE: Before you troubleshoot, record all freeze data and any on-board snapshot, and review the general troubleshooting information. If DTC P0101, P0108, P1128, and/or P1129 are stored at the same time as DTC P2221, troubleshoot those DTCs first, then recheck for DTC P2221. 1. Turn the ignit

© 2016-2025 Copyright www.hcrv.net