Honda CR-V: Cleaning the Seat Belts

Dirt build-up in the loops of the seat

Dirt build-up in the loops of the seat belt anchors can cause the belts to retract slowly. Wipe the insides of the loops with a clean cloth dampened in mild soap and warm water or isopropyl alcohol.

If your seat belts get dirty, use a soft brush with a mixture of mild soap and warm water to clean them. Do not use bleach, dye, or cleaning solvents. Let the belts air-dry before you use the vehicle.

READ NEXT:

 Floor Mats

The floor mats that came with your vehicle hook over the floor mat anchors. This keeps the floor mats from sliding forward, possibly interfering with the pedals, or backwards, making the f

 Audio Antenna

Your vehicle is equipped with an antenna at the rear of the roof . Bef ore using a ‘‘drive-through’’ car wash, remove the antenna by unscrewing it by hand. This prevents the antenna

 Dust and Pollen Filter

This filter removes the dust and pollen that is brought in fromthe outside through the heating and cooling system/climate control system. Have your dealer replace this filter when this serv

SEE MORE:

 Seat Belts

Component Location Index REAR CENTER SEAT BELT REAR CENTER SEAT BELT BUCKLE and LEFT REAR SEAT BELT BUCKLE REAR SEAT BELT FRONT SEAT BELT FRONT SEAT BELT BUCKLES RIGHT FRONT SEAT BELT LOWER ANCHOR Front Seat Belt Replacement Special Tools Required KTC trim tool set SOJATP2014 * * Availab

 Turn Signal/Hazard Flasher

Component Location Index TURN SIGNAL SWITCH (Built into the combination light switch) TURN SIGNAL INDICATORS HAZARD WARNING SWITCH MICU (Built into the under-dash fuse/relay box) Circuit Diagram MICU Input Test NOTE: Before testing, troubleshoot the B-CAN System Diagnosis Test Mode A. 1.

© 2016-2025 Copyright www.hcrv.net