Honda CR-V: Additional Information on Recommended Discs

Honda CR-V (2006–2011) Owner's Manual / Features / Protecting Your Discs / Additional Information on Recommended Discs

The disc player/changer has a sophisticated and delicate mechanism. If you insert a damaged disc as indicated in this section, it may become stuck inside and damage the audio unit.

Examples of these discs are shown to the right:

1. Bubbled, wrinkled, labeled, and excessively thick discs

1. Bubbled, wrinkled, labeled, and excessively thick discs

2. Damaged discs

2. Damaged discs

3. Poor quality discs

3. Poor quality discs

4. Small, irregular shaped discs

4. Small, irregular shaped discs

5. Discs with scratches, dirty discs

5. Discs with scratches, dirty discs

CD-R or CD-RW may not play due to the recording conditions.

Scratches and fingerprints on the discs may cause the sound to skip.

Recommended discs are printed

Recommended discs are printed with the following logo.

Audio unit may not play the

Audio unit may not play the following formats.

READ NEXT:

 Remote Audio Controls

If equipped Three controls for the audio system are mounted in the steering wheel hub. These let you control basic functions without removing your hand from the wheel. The VOL button adjus

 Playing an Optional Audio Unit

Your vehicle has the auxiliary input jack on the front panel, on the center table, or in the console compartment, depending on models. The system will accept auxiliary input from standard

 Radio Theft Protection

Your vehicle’s audio system will disable itself if it is disconnected from electrical power for any reason. To make it work again, you must enter a specific code using the preset buttons (i

SEE MORE:

 To Stop Playing a PC Card

To play the radio when a PC card is playing, press the AM/FM button or touch the FM1, FM2, AM, XM1, or XM2 icon. If a disc is in the audio unit, press the CD/XM button or touch the CD icon to play the disc. If a CD or CDs are in the CD changer, touch the CDC icon to play the disc(s).

 DTC P0705: Short in Transmission Range Switch Circuit (Multiple Shift-Position Input)

NOTE: Before you troubleshoot, record all freeze data and any on-board snapshot, and review General Troubleshooting Information. This code is caused by an electrical circuit problem and cannot be caused by a mechanical problem in the transmission. 1. Clear the DTC with the HDS. 2. Start the

© 2016-2026 Copyright www.hcrv.net