Honda CR-V manuals

Honda CR-V: Windshield Wiper

Honda CR-V (2006–2011) Owner's Manual / Instruments and Controls / Windshield Wipers and Washers / Windshield Wiper

1. MIST

1. MIST
2. OFF
3. INT Intermittent
4. LO Low speed
5. HI High speed
6. Windshield washers

Push the right lever up or down to select a position.

MIST - The wipers run at high speed until you release the lever.

OFF - The wipers are not activated.

INT - The wipers operate every few seconds. At low speed and high speed, the wipers run continuously.

On all models except LX

Vary the delay by turning the adjustment ring. If you turn it to the shortest delay (wipers change to low speed position), the wipers change to low speed operation when the vehicle speed exceeds 12 mph (20 km/h).

The length of the wiper interval is varied automatically according to the vehicle’s speed.

LO - The wipers run at low speed.

HI - The wipers run at high speed.

READ NEXT:

 WindshieldWashers

Pull the wiper control lever toward you, and hold it. The washers spray until you release the lever. The wipers run at low speed, then complete one more sweep after you release the lever.

 Rear Window Wiper and Washer

1. OFF When you turn the wiper switch to the ‘‘OFF’’ position, the wiper will return to its parked position. 2. Rotate the switch clockwise to turn the rear window wiper ON. The

 Turn Signal and Headlights

1. Turn Signal 2. OFF 3. Parking and interior lights 4. AUTO 5. Headlights on 6. High Beams 7. Flash high beams *: If equipped Turn Signal - Push down on the lever to signal a left turn

SEE MORE:

 Accessory Power Sockets

Your vehicle has two or three accessory power sockets depending on the model. To use an accessory power socket, the ignition switch must be in the ACCESSORY (I) or ON (II) position. Each socket is intended to supply power for 12 volt DC accessories that are rated 120 watts or l

 Power Mirrors

Component Location Index POWER MIRRORS/POWER MIRROR DEFOGGERS AUXILIARY UNDER-HOOD RELAY BOX POWER MIRROR DEFOGGER RELAY REAR WINDOW DEFOGGER SWITCH/ MIRROR DEFOGGER SWITCH POWER MIRROR SWITCH Circuit Diagram Function Test 1. Remove the power mirror switch. 2. Disconnect the 13P co

© 2016-2025 Copyright www.hcrv.net