Honda CR-V: Audio Antenna

Your vehicle is equipped with an

Your vehicle is equipped with an antenna at the rear of the roof . Bef ore using a ‘‘drive-through’’ car wash, remove the antenna by unscrewing it by hand. This prevents the antenna f rom being damaged by the car wash brushes.

READ NEXT:

 Dust and Pollen Filter

This filter removes the dust and pollen that is brought in fromthe outside through the heating and cooling system/climate control system. Have your dealer replace this filter when this serv

 Wiper Blades

Check the condition of the wiper blades at least every six months. Replace them if you find signs of cracking in the rubber, areas that are getting hard, or if they leave streaks and unwiped

 Tires

To safely operate your vehicle, your tires must be the proper type and size, in good condition with adequate tread, and correctly inflated. The following pages give more detailed information

SEE MORE:

 Valve Clearance Adjustment

Special Tools Required Adjuster 07MAA-PR70110 Locknut wrench 07MAA-PR70120 NOTE: Adjust the valves only when the cylinder head temperature is less than 100 ºF (38 ºC). 1. Remove the cylinder head cover. 2. Set the No.1 piston at top dead center (TDC). The punch mark (A) on the variable valve

 ATF Replacement

NOTE: Keep all foreign particles out of the transmission. 1. Park the vehicle on the level ground. 2. Warm up the engine to normal operating temperature (the radiator fan comes on), and turn the engine off. 3. Remove the drain plug (A), and drain the automatic transmission fluid (ATF). NOTE: If

© 2016-2025 Copyright www.hcrv.net