Honda CR-V manuals

Honda CR-V: Replacing a Parking Light/Front Side Marker Light Bulb

Honda CR-V (2006–2011) Owner's Manual / Maintenance / Lights / Replacing a Parking Light/Front Side Marker Light Bulb

1. Open the hood.

1. Open the hood.

To change the parking light/front side marker on the driver’s side, remove the fuse box fromits stay by pulling out.

2. Remove the socket from the

2. Remove the socket from the headlight assembly by turning it one-quarter turn counterclockwise.

3. Pull the bulb straight out of its socket. Push the new bulb straight into the socket until it bottoms.

4. Insert the socket back into the headlight assembly. Turn it clockwise to lock it in place.

5. Turn on the lights to make sure the new bulb is working.

6. (Driver’s side)
Reinstall the fuse box in place securely.

READ NEXT:

 Replacing Rear Bulbs

1. Open the tailgate. Place a cloth on the edge of the cover to prevent scratches. Remove the covers by carefully prying on the edge with a small flat-tip screwdriver. 2. Use a Phillips-h

 Replacing a High-mount Brake Light Bulb

1. Open the tailgate. Unlatch the top of the cover by pulling back on it with your hands. 2. Place a cloth on the side edge of the cover to prevent scratches. Remove the cover by carefully

 Cleaning the Seat Belts

Dirt build-up in the loops of the seat belt anchors can cause the belts to retract slowly. Wipe the insides of the loops with a clean cloth dampened in mild soap and warm water or isopropy

SEE MORE:

 Camshaft Inspection

NOTE: Do not rotate the camshaft during inspection. 1. Remove the rocker arm assembly. 2. Put the rocker shaft holders, camshaft, and camshaft holders on the cylinder head, then tighten the bolts, in sequence, to the specified torque. NOTE: If the engine does not have bolt 21, skip it and continu

 Compass Zone Selection

In most areas, there is a variation between magnetic north and true north. Zone selection is required so the compass can compensate for this variation. To check and select the zone, do this: 1. Press and hold the select/reset knob for 10 seconds to change the display to the reset mode

© 2016-2025 Copyright www.hcrv.net