Honda CR-V: Replacing a Parking Light/Front Side Marker Light Bulb

Honda CR-V (2006–2011) Owner's Manual / Maintenance / Lights / Replacing a Parking Light/Front Side Marker Light Bulb

1. Open the hood.

1. Open the hood.

To change the parking light/front side marker on the driver’s side, remove the fuse box fromits stay by pulling out.

2. Remove the socket from the

2. Remove the socket from the headlight assembly by turning it one-quarter turn counterclockwise.

3. Pull the bulb straight out of its socket. Push the new bulb straight into the socket until it bottoms.

4. Insert the socket back into the headlight assembly. Turn it clockwise to lock it in place.

5. Turn on the lights to make sure the new bulb is working.

6. (Driver’s side)
Reinstall the fuse box in place securely.

READ NEXT:

 Replacing Rear Bulbs

1. Open the tailgate. Place a cloth on the edge of the cover to prevent scratches. Remove the covers by carefully prying on the edge with a small flat-tip screwdriver. 2. Use a Phillips-h

 Replacing a High-mount Brake Light Bulb

1. Open the tailgate. Unlatch the top of the cover by pulling back on it with your hands. 2. Place a cloth on the side edge of the cover to prevent scratches. Remove the cover by carefully

 Cleaning the Seat Belts

Dirt build-up in the loops of the seat belt anchors can cause the belts to retract slowly. Wipe the insides of the loops with a clean cloth dampened in mild soap and warm water or isopropy

SEE MORE:

 Driveshaft Inspection

1. Check the inboard boot (A) and the outboard boot (B) on the driveshaft (C) for cracks, damage, leaking grease, and loose boot bands (D). If any damage is found, replace the boot and boot bands. 2. Turn the driveshaft by hand, and make sure the splines (E) and joint are not excessively loose. 3.

 Valve, Spring, and Valve Seal Installation

Special Tools Required Stem seal driver 07PAD-001 0000 Valve spring compressor attachment 07757-PJ1010A 1. Coat the valve stems with engine oil. Install the valves in the valve guides. 2. Check that the valves move up and down smoothly. 3. Install the spring seats on the cylinder head. 4. Ins

© 2016-2025 Copyright www.hcrv.net