Honda CR-V manuals

Honda CR-V: Replacing a Parking Light/Front Side Marker Light Bulb

Honda CR-V (2006–2011) Owner's Manual / Maintenance / Lights / Replacing a Parking Light/Front Side Marker Light Bulb

1. Open the hood.

1. Open the hood.

To change the parking light/front side marker on the driver’s side, remove the fuse box fromits stay by pulling out.

2. Remove the socket from the

2. Remove the socket from the headlight assembly by turning it one-quarter turn counterclockwise.

3. Pull the bulb straight out of its socket. Push the new bulb straight into the socket until it bottoms.

4. Insert the socket back into the headlight assembly. Turn it clockwise to lock it in place.

5. Turn on the lights to make sure the new bulb is working.

6. (Driver’s side)
Reinstall the fuse box in place securely.

READ NEXT:

 Replacing Rear Bulbs

1. Open the tailgate. Place a cloth on the edge of the cover to prevent scratches. Remove the covers by carefully prying on the edge with a small flat-tip screwdriver. 2. Use a Phillips-h

 Replacing a High-mount Brake Light Bulb

1. Open the tailgate. Unlatch the top of the cover by pulling back on it with your hands. 2. Place a cloth on the side edge of the cover to prevent scratches. Remove the cover by carefully

 Cleaning the Seat Belts

Dirt build-up in the loops of the seat belt anchors can cause the belts to retract slowly. Wipe the insides of the loops with a clean cloth dampened in mild soap and warm water or isopropy

SEE MORE:

 Valve Body

Valve Body and ATF Strainer Removal NOTE: The illustration shows the 4WD transmission; the 2WD is similar. 1. Remove the ATF feed pipes (A) and ATF joint pipes (B). 2. Remove the ATF strainer (C) (two bolts), 3. Remove the regulator valve body (D) (eight bolts), 4. Remove the stator shaft (E) and

 DTC Troubleshooting

DTC B1000: Communication Bus Line Error (Bus-off) 1. Clear the DTCs with the HDS. 2. Turn the ignition switch OFF, and then back ON (II). 3. Wait for 6 seconds or more. 4. Check for DTCs with the HDS. Is DTCs B1000 and/or B1008 and B1011 indicated? YES-Go to step 5. NO-Intermittent failure, the

© 2016-2025 Copyright www.hcrv.net