Honda CR-V: Glove Box Removal/Installation
NOTE: Take care not to scratch the dashboard and related parts.
1. Open the glove box (A), and detach the hook (B) of the glove box damper. While holding the glove box, release the glove box stop (C) on each side from the dashboard by pushing them in.
2. Close the glove box (A), then remove the bolts and remove the glove box.
3. Install the glove box in the reverse order of removal.
Glove Box Damper Replacement
NOTE:
- Put on gloves to protect your hands.
- Take care not to scratch the dashboard and related parts.
1. Remove the these items:
- Glove box
- Dashboard side cover, passenger's side
2. Detach the clip of the glove box damper (A) by pinching it to release from inside the dashboard, then remove the damper.
3. Install the damper in the reverse order of removal.
Glove Box Striker Replacement
NOTE: Take care not to scratch the dashboard and related parts.
1. For some models: Remove the glove box light (A).
2. Detach the hook of the glove box damper and release the glove box stop on each side from the dashboard by pushing them inside (see step 1).
3. Remove the screws, then remove the glove box striker (B).
4. Install the striker in the reverse order of removal.
Dashboard Glove Box Cover Removal/Installation
NOTE: Take care not to scratch the dashboard and related parts.
1. Remove the dashboard/steering hanger beam.
2. Remove the steering/steering hanger beam from the dashboard.
3. Remove the screws, then remove the dashboard glove box center cover (A) or the dashboard glove box outer cover (B).
Center
Outer
4. Install the cover in the reverse order of removal.
READ NEXT:
Column Cover Removal/Installation
SRS components are located in this area. Review the
SRS component locations and the
precautions and procedures before
doing repairs or service.
NOTE: Take care not to scratch the dashboard and
relate
Seats
Component Location Index
REAR SEAT
Removal/Installation
Armrest Removal/Installation
Armrest Cover Replacement
Right Rear Seat Cover Replacement
Left Rear Seat Cover Replacement
Right S
Front Seat
Front Seat Active Head Restraint Inspection
NOTE: If the vehicle has been in a collision, always
inspect the active head restraints, even if they appear
reusable, by doing the following procedure.
Res
SEE MORE:
Radiator Replacement
For Japan-produced Model
1. Drain the engine coolant.
2. Remove the hood support rod, then use it as shown
to prop the hood in the wide-open position.
3. Remove the bulkhead cover.
4. Remove the coolant reservoir hose (A) and upper
radiator hose (B).
5. Raise the vehicle on the lift to full heig
Valve Clearance Adjustment
Special Tools Required
Adjuster 07MAA-PR70110
Locknut wrench 07MAA-PR70120
NOTE: Adjust the valves only when the cylinder head
temperature is less than 100 ºF (38 ºC).
1. Remove the cylinder head cover.
2. Set the No.1 piston at top dead center (TDC). The
punch mark (A) on the variable valve
