Honda CR-V: Replacing a Front Turn Signal Light Bulb

Honda CR-V (2006–2011) Owner's Manual / Maintenance / Lights / Replacing a Front Turn Signal Light Bulb

1. Open the hood.

1. Open the hood.

To change the turn signal bulb on the driver’s side, remove the engine coolant reserve tank by pulling it out of its holder.

2. Remove the socket from the

2. Remove the socket from the headlight assembly by turning it one-quarter turn counterclockwise.

3. Pull the bulb straight out of its socket. Push the new bulb straight into the socket until it bottoms.

4. Insert the socket back into the headlight assembly. Turn it clockwise to lock it in place.

5. Turn on the lights to make sure the new bulb is working.

6. (Driver’s side)
Reinstall the coolant reserve tank.

READ NEXT:

 Replacing a Parking Light/Front Side Marker Light Bulb

1. Open the hood. To change the parking light/front side marker on the driver’s side, remove the fuse box fromits stay by pulling out. 2. Remove the socket from the headlight assembly

 Replacing Rear Bulbs

1. Open the tailgate. Place a cloth on the edge of the cover to prevent scratches. Remove the covers by carefully prying on the edge with a small flat-tip screwdriver. 2. Use a Phillips-h

 Replacing a High-mount Brake Light Bulb

1. Open the tailgate. Unlatch the top of the cover by pulling back on it with your hands. 2. Place a cloth on the side edge of the cover to prevent scratches. Remove the cover by carefully

SEE MORE:

 DTC 71-2x ("x" can be 0 thru 9 or A thru F): Short in Driver's Seat Position Sensor

NOTE: Before doing this troubleshooting procedure, review SRS Precautions and Procedures. 1. Erase the DTC memory. 2. Turn the ignition switch ON (II), and check that the SRS indicator comes on for about 6 seconds and then goes off. Does the SRS indicator stay on, and is DTC 71-2x indicated? YES-G

 To Load a Disc

The in-dash disc player is behind the navigation screen. To use the disc player, press the OPEN button beside the screen. The screen folds back, and the disc slot appears. Insert a disc about halfway into the disc slot. The drive will pull the disc in the rest of the way and beg

© 2016-2025 Copyright www.hcrv.net