Honda CR-V: Replacing a Front Turn Signal Light Bulb

Honda CR-V (2006–2011) Owner's Manual / Maintenance / Lights / Replacing a Front Turn Signal Light Bulb

1. Open the hood.

1. Open the hood.

To change the turn signal bulb on the driver’s side, remove the engine coolant reserve tank by pulling it out of its holder.

2. Remove the socket from the

2. Remove the socket from the headlight assembly by turning it one-quarter turn counterclockwise.

3. Pull the bulb straight out of its socket. Push the new bulb straight into the socket until it bottoms.

4. Insert the socket back into the headlight assembly. Turn it clockwise to lock it in place.

5. Turn on the lights to make sure the new bulb is working.

6. (Driver’s side)
Reinstall the coolant reserve tank.

READ NEXT:

 Replacing a Parking Light/Front Side Marker Light Bulb

1. Open the hood. To change the parking light/front side marker on the driver’s side, remove the fuse box fromits stay by pulling out. 2. Remove the socket from the headlight assembly

 Replacing Rear Bulbs

1. Open the tailgate. Place a cloth on the edge of the cover to prevent scratches. Remove the covers by carefully prying on the edge with a small flat-tip screwdriver. 2. Use a Phillips-h

 Replacing a High-mount Brake Light Bulb

1. Open the tailgate. Unlatch the top of the cover by pulling back on it with your hands. 2. Place a cloth on the side edge of the cover to prevent scratches. Remove the cover by carefully

SEE MORE:

 Crankshaft Installation

Special Tools Required Driver 077 49-00 10000 Oil seal driver attachment, 96 mm 07ZAD-PNAA.100 1. Check the connecting rod bearing clearance with plastigage. 2. Check the main bearing clearance with plastigage. 3. Install the bearing halves in the engine block and connecting rods. 4. Apply a

 Component Replacement/Inspection After Deployment

NOTE: Before doing any SRS repairs, use the HDS SRS menu method to check for DTCs; refer to the DTC Troubleshooting Index for the less obvious deployed parts (seat belt tensioners, front impact sensors, side airbag sensors, etc.) Do not replace the ODS unit unless it is physically damaged or

© 2016-2025 Copyright www.hcrv.net