Honda CR-V: Replacing a Front Turn Signal Light Bulb

Honda CR-V (2006–2011) Owner's Manual / Maintenance / Lights / Replacing a Front Turn Signal Light Bulb

1. Open the hood.

1. Open the hood.

To change the turn signal bulb on the driver’s side, remove the engine coolant reserve tank by pulling it out of its holder.

2. Remove the socket from the

2. Remove the socket from the headlight assembly by turning it one-quarter turn counterclockwise.

3. Pull the bulb straight out of its socket. Push the new bulb straight into the socket until it bottoms.

4. Insert the socket back into the headlight assembly. Turn it clockwise to lock it in place.

5. Turn on the lights to make sure the new bulb is working.

6. (Driver’s side)
Reinstall the coolant reserve tank.

READ NEXT:

 Replacing a Parking Light/Front Side Marker Light Bulb

1. Open the hood. To change the parking light/front side marker on the driver’s side, remove the fuse box fromits stay by pulling out. 2. Remove the socket from the headlight assembly

 Replacing Rear Bulbs

1. Open the tailgate. Place a cloth on the edge of the cover to prevent scratches. Remove the covers by carefully prying on the edge with a small flat-tip screwdriver. 2. Use a Phillips-h

 Replacing a High-mount Brake Light Bulb

1. Open the tailgate. Unlatch the top of the cover by pulling back on it with your hands. 2. Place a cloth on the side edge of the cover to prevent scratches. Remove the cover by carefully

SEE MORE:

 DTC P050A: Cold Start Idle Air Control System Performance Problem

NOTE: Before you troubleshoot, record all freeze data and any on-board snapshot, and review the general troubleshooting information. 1. Turn the ignition switch ON (II). 2. Check for Temporary DTCs or DTCs with the HDS. Are any Temporary DTCs or DTCs other than P050A indicated? YES-Go to the indi

 To Change or Select Files

Use the SKIP button while a USB flash memory device is playing to change files. SKIP - Each time you press the (SKIP +) button, the system skips forward to the beginning of the next file. Press the (SKIP -) button, to skip backward to the beginning of the current file. Press it ag

© 2016-2025 Copyright www.hcrv.net