Honda CR-V: Replacing a Front Turn Signal Light Bulb
Honda CR-V (2006–2011) Owner's Manual / Maintenance / Lights / Replacing a Front Turn Signal Light Bulb
1. Open the hood.
To change the turn signal bulb on the driver’s side, remove the engine coolant reserve tank by pulling it out of its holder.
2. Remove the socket from the headlight assembly by turning it one-quarter turn counterclockwise.
3. Pull the bulb straight out of its socket. Push the new bulb straight into the socket until it bottoms.
4. Insert the socket back into the headlight assembly. Turn it clockwise to lock it in place.
5. Turn on the lights to make sure the new bulb is working.
6. (Driver’s side)
Reinstall the coolant reserve tank.
READ NEXT:
Replacing a Parking Light/Front Side Marker Light Bulb
1. Open the hood.
To change the parking light/front
side marker on the driver’s side,
remove the fuse box fromits stay
by pulling out.
2. Remove the socket from the
headlight assembly
Replacing Rear Bulbs
1. Open the tailgate. Place a cloth on
the edge of the cover to prevent
scratches. Remove the covers by
carefully prying on the edge with a
small flat-tip screwdriver.
2. Use a Phillips-h
Replacing a High-mount Brake Light Bulb
1. Open the tailgate.
Unlatch the top of the cover by
pulling back on it with your hands.
2. Place a cloth on the side edge of
the cover to prevent scratches.
Remove the cover by carefully
SEE MORE:
DTC 33-9x ("x" can be 0 thru 9 or A thru F):
Short to Ground in Left Side Curtain Airbag
Inflator
Special Tools Required
SRS inflator simulator 07SAZ-TB4011A
SRS simulator lead L 070AZ-SNAA300
NOTE: Before doing this troubleshooting procedure,
review SRS Precautions and Procedures.
1. Erase the DTC memory.
2. Turn the ignition switch ON (II), and check that the
SRS indicator comes on for a
Symptom Troubleshooting
VSA activation indicator does not go off, and
no DTCs are stored
1. Turn the ignition switch ON (II), and watch the VSA
activation indicator.
Does VSA activation indicator go off within 2 seconds? YES-The system is OK at
this time.
NO-Go to step 2.
2. Turn the ignition switch OFF.
3. Disconnect
© 2016-2025 Copyright www.hcrv.net
