Honda CR-V: Fuel Fill Door

Fuel Fill Door Adjustment

1. Remove the nut (A), then remove the open spring (B).

Honda CR-V. Fuel Fill Door

2. Slightly loosen the hinge mounting bolts (A).

Honda CR-V. Fuel Fill Door

3. Adjust the fuel fill door (B) in or out until it's flush with the body, and up or down as necessary to equalize the gaps.

4. Tighten the hinge mounting bolts.

5. Check that the fuel fill door opens properly and locks securely, and check that the rear of the door is flush with the body.

6. Reinstall the open spring and nut.

7. Apply multipurpose grease to each location indicated by the arrows.

Honda CR-V. Fuel Fill Door

8. Apply touch-up paint to the hinge mounting bolts and around the hinges.

Fuel Cap Adapter Replacement

NOTE: Take care not to scratch the body.

1. Remove the fuel pipe protector.

2. Remove the cap (A) by turning it counterclockwise.

Honda CR-V. Fuel Fill Door

3. From under the body, push out the hooks (A). Then turn the fuel cap adapter (B), and remove it from the fuel pipe.

Honda CR-V. Fuel Fill Door

4. Install the adapter in the reverse order of removal.

READ NEXT:

 Exterior Trim

 Upper/Lower Front Grille Replacement

Upper Front Grille Replacement NOTE: Take care not to scratch the bumper and grille. 1. Remove the front bumper. 2. Remove the clips from the back of the front grille and release the hooks (A), then

 Cowl Cover Replacement

Special Tools Required KTC trim tool set SOJATP2014 * * Available through the American Honda Tool and Equipment Program; call 888-424-6857 NOTE: Put on gloves to protect your hands. Take care not t

SEE MORE:

 All Children Should Sit in a Back Seat

According to statistics, children of all ages and sizes are safer when they are restrained in a back seat. The National Highway Traffic Safety Administration and Transport Canada recommend that all children aged 12 and under be properly restrained in a back seat. Some states have laws

 Brake Booster

Brake Booster Test Functional Test 1. With the engine stopped, press the brake pedal several times to deplete the vacuum reservoir, then press the brake pedal hard, and hold it for 15 seconds. If the brake pedal sinks, either the master cylinder is bypassing internally, or the brake system is lea

© 2016-2025 Copyright www.hcrv.net