Honda CR-V: Daytime Running Lights
Honda CR-V (2006–2011) Owner's Manual / Instruments and Controls / Daytime Running Lights
With the headlight switch in the off
or
position,
the high beam
headlights and the high beam
indicator come on with reduced
brightness when you turn the
ignition switch to the ON (II)
position and release the parking
brake. They remain on until you turn
the ignition switch off, even if you
set the parking brake.
The headlights revert to normal operation when you turn them on with the switch.
READ NEXT:
Instrument Panel Brightness
You can change the instrument panel
brightness only when the light
switch is on.
Turn the knob on the lower part of
the instrument panel to adjust the
brightness.
You will hear a beep wh
HazardWarning Button
Push the button between the center
vents to turn on the hazard warning
lights (four-way flashers). This
causes all four outside turn signals
and both indicators in the instrument
panel t
Rear Window Defogger
The rear window defogger will clear
fog, frost, and thin ice from the
window. Push the defogger button to
turn it on and off. The indicator in
the button comes on to show the
defogger is
SEE MORE:
Column Cover Removal/Installation
SRS components are located in this area. Review the
SRS component locations and the
precautions and procedures before
doing repairs or service.
NOTE: Take care not to scratch the dashboard and
related parts.
1. Release the tilt/telescopic lock lever, tilt the
steering wheel to fully down, and pull
DTC P1009: VTC Advance Malfunction
NOTE:
Before you troubleshoot, record all freeze data and any on-board
snapshot, and review the general troubleshooting information.
If DTC P0341 is stored at the same time as DTC P1009,
troubleshoot DTC P1009 first, then recheck for DTC
P0341.
1. Turn the ignition switch ON (II).
2. Clear
© 2016-2025 Copyright www.hcrv.net
