Honda CR-V: Remote Starting System - If Equipped

This system uses the Remote Keyless Entry (RKE) transmitter to start the engine conveniently from outside the vehicle while still maintaining security. The system has a range of approximately 300 ft (91 m).

NOTE:

How To Use Remote Start

All of the following conditions must be met before the engine will remote start:

WARNING!

Remote Start Abort Message On Electronic Vehicle Information Center (EVIC) - If Equipped

The following messages will display in the EVIC if the vehicle fails to remote start or exits remote start prematurely:

The EVIC message stays active until the ignition is turned to the ON/RUN position.

To Enter Remote Start Mode

Press and release the REMOTE START button on the RKE transmitter twice within five seconds.

The parking lights will flash, vehicle doors will lock, and the horn will chirp twice (if programmed). Once the vehicle has started, the engine will run for 15 minutes.

NOTE:

To Exit Remote Start Mode Without Driving The Vehicle

Press and release the REMOTE START button one time or allow the engine to run for the entire 15-minute cycle.

NOTE: To avoid unintentional shut downs, the system will disable the one time press of the REMOTE START button for two seconds after receiving a valid Remote Start request.

To Exit Remote Start Mode And Drive The Vehicle

Before the end of the 15-minute cycle, press and release the UNLOCK button on the RKE transmitter to unlock the doors and disarm the Vehicle Security Alarm System (if equipped). Then, prior to the end of the 15 minute cycle, cycle the ignition to the ON/RUN position.

Remote Start Comfort Systems - If Equipped

When remote start is activated, the heated steering wheel and driver heated seat features will automatically turn on in cold weather. In warm weather, the driver vented seat feature will automatically turn on when the remote start is activated. These features will stay on through the duration of remote start or until the ignition switch is turned to the ON/RUN position.

The Remote Start Comfort System can be activated and deactivated through the Uconnect System. For more information on Remote Start Comfort System operation refer to "Customer Programmable Features" in "Uconnect Settings" in "Understanding Your Instrument Panel".

READ NEXT:

 Door Locks

 Manual Door Locks

Front and rear doors may be locked by moving the lock knob down or unlocked by moving the lock knob up. Door Lock Knob Front doors may be opened with the inside door handle without lifting the lock k

 Power Door Locks - If Equipped

A power door LOCK switch is on each front door trim panel. Use this switch to lock or unlock the doors. Power Door Lock Switch Location If you press the power door LOCK switch while the Key Fob is in

SEE MORE:

 Charging System

Component Location Index CHARGING SYSTEM INDICATOR (In the gauge control module) UNDER-HOOD FUSE/RELAY BOX (Has built-in ELECTRICAL LOAD DETECTOR [ELD] UNIT) BATTERY ALTERNATOR DRIVE BELT AUTO-TENSIONER Symptom Troubleshooting Index Charging system indicator does not come

 Wiper/Washer Switch Test/Replacement

1. Remove the steering column covers. 2. Disconnect the dashboard wire harness 8P connector (A) from the wiper/washer switch (B). 3. Remove the two screws, then slide out the wiper/ washer switch. 4. Inspect the connector terminals to be sure they are all making good contact. If the terminals a

© 2016-2023 Copyright www.hcrv.net