Honda CR-V: Loading CDs in the Changer
Your vehicle has the CD changer in the center console.
CD-R, CD-RWdisc, and CD compressed inMP3 andWMA will not work in this unit. Video CDs and DVD discs also will not work.
Do not spill any liquids on the center console. Spilled liquids can damage electrical components in the CD changer.
1. Open the center console cover, then slide open the CD changer cover by pulling it rearward.
2. Push the EJECT button to remove the CD magazine. The magazine will pop up automatically.
3. To install a CD into the magazine, push the button while pulling out on the tab.
4. Put a CDon the tray with the printed surface facing up as shown.
5. Reinstall the tray in the magazine.
Repeat this procedure to open the other five trays.
6. Store all six trays in the magazine, and reinstall the magazine in the CD changer as shown.
7. Make sure to slide the CD changer cover closed until it clicks.
To remove CDs from the CD changer, refer to the loading procedure.
READ NEXT:
To Play a CD
To play CDs, the ignition switch
must be in the ACCESSORY (I) or
ON (II) position.
You operate the CD changer with
the same controls used for the indash
disc player or the radio. To
select
To Stop Playing a CD
Press the AM/FMor CD/XM
button to switch to the radio or
satellite radio while a CD is playing.
If there is a PC card in the audio unit,
touch the CARD icon to switch to
the PC card while a C
CD Changer Error Messages (EX-L model with navigation system)
If you see an error message in the
display while playing a disc, find the
cause in the chart to the right. If you
cannot clear the error message, take
your vehicle to your dealer.
The cha
SEE MORE:
Hood
Hood Adjustment
1. Remove these items:
Front bulkhead cover
Front fender trim
Cowl cover
2. Slightly loosen each bolt (A).
3. Adjust the hood alignment in this sequence:
Adjust the hood right and left, as well as forward and rearward, by
using the elongated holes in the hood
hinges (B).
Damper/Spring
Damper/Spring Removal and Installation
Removal
1. Turn the ignition switch ON (II), then turn on the
windshield wipers. Turn the ignition switch off
when the wipers are near the A-pillars.
2. Raise the front of the vehicle, and support it with safety stands in the
proper locations.
3. Remove th
