Honda CR-V: Relay and Control Unit Locations

Honda CR-V (2006–2011) Service Manual / Body Electrical / Relay and Control Unit Locations

Engine Compartment

Honda CR-V. Relay and Control Unit Locations

Dashboard

Honda CR-V. Relay and Control Unit Locations

Honda CR-V. Relay and Control Unit Locations

Honda CR-V. Relay and Control Unit Locations

Driver's Door

Honda CR-V. Relay and Control Unit Locations

Seat

Honda CR-V. Relay and Control Unit Locations

READ NEXT:

 Connectors and Harnesses

Connector Index Identification numbers have been assigned to in-line connectors, junction connectors, and terminals. The number is preceded by the letter ºC" for connectors "G" for ground terminals

 Under-hood/dash Fuse/Relay Box

Under-hood Fuse/Relay Box Removal and Installation Removal 1. Make sure you have the anti-theft codes for the audio and navigation system. If equipped with XM radio, write down the XM radio presets.

 Battery

WARNING A battery can explode if you do not follow the proper procedure, causing serious injury to anyone nearby. Follow all procedures carefully and keep sparks and open flames away from the battery.

SEE MORE:

 Door Lock

Door Lock Actuator Test Driver's Door and Left Rear Door 1. Remove the door panel. Front Rear 2. Disconnect the 10P connector (A) from the actuator (B). NOTE: The illustration shows the driver's door. 3. Check the actuator operation by connecting power and ground according to the table. To

 Brake System Indicator

The brake system indicator normally comes on when you turn the ignition switch to the ON (II) position, and as a reminder to check the parking brake. It will stay on if you do not fully release the parking brake. If the brake system indicator comes on while driving, the brake fluid le

© 2016-2025 Copyright www.hcrv.net