Honda CR-V: Relay and Control Unit Locations

Honda CR-V (2006–2011) Service Manual / Body Electrical / Relay and Control Unit Locations

Engine Compartment

Honda CR-V. Relay and Control Unit Locations

Dashboard

Honda CR-V. Relay and Control Unit Locations

Honda CR-V. Relay and Control Unit Locations

Honda CR-V. Relay and Control Unit Locations

Driver's Door

Honda CR-V. Relay and Control Unit Locations

Seat

Honda CR-V. Relay and Control Unit Locations

READ NEXT:

 Connectors and Harnesses

Connector Index Identification numbers have been assigned to in-line connectors, junction connectors, and terminals. The number is preceded by the letter ºC" for connectors "G" for ground terminals

 Under-hood/dash Fuse/Relay Box

Under-hood Fuse/Relay Box Removal and Installation Removal 1. Make sure you have the anti-theft codes for the audio and navigation system. If equipped with XM radio, write down the XM radio presets.

 Battery

WARNING A battery can explode if you do not follow the proper procedure, causing serious injury to anyone nearby. Follow all procedures carefully and keep sparks and open flames away from the battery.

SEE MORE:

 EGR System

Component Location Index EXHAUST GAS RECIRCULATION (EGR) VALVE POWERTRAIN CONTROL MODULE (PCM) EXHAUST GAS RECIRCULATION (EGR) PLATE DTC Troubleshooting DTC P0401: EGR Insufficient Flow NOTE: Before you troubleshoot, record all freeze data and any on-board snapshot, and review the genera

 Boot Band Installation

Special Tools Required Boot band tool, KD-3191 or equivalent, commercially available Boot band pliers, Kent-Moore J-35910 or equivalent, commercially available Double Loop Type 1. Fit the boot ends onto the driveshaft and the inboard joint, then install the new double loop band (A) onto the boot. N

© 2016-2025 Copyright www.hcrv.net