Honda CR-V: Instrument Panel Brightness
Honda CR-V (2006–2011) Owner's Manual / Instruments and Controls / Instrument Panel Brightness
You can change the instrument panel brightness only when the light switch is on.
Turn the knob on the lower part of the instrument panel to adjust the brightness.
You will hear a beep when maximum or minimum brightness is reached.
To reduce glare at night, the
instrument panel illumination dims
when you turn the light switch to
or 
.
Turning the select/
reset knob fully to the right until you
hear a beep will cancel the reduced
brightness.
READ NEXT:
HazardWarning Button
Push the button between the center
vents to turn on the hazard warning
lights (four-way flashers). This
causes all four outside turn signals
and both indicators in the instrument
panel t
Rear Window Defogger
The rear window defogger will clear
fog, frost, and thin ice from the
window. Push the defogger button to
turn it on and off. The indicator in
the button comes on to show the
defogger is
Parking Brake
To apply the parking brake, push the
pedal down with your foot. To
release it, push on the pedal again.
The parking brake indicator on the
instrument panel should go out when
the parking
SEE MORE:
DTC P0731: Problem in 1st Clutch and 1st
Clutch Hydraulic Circuit
NOTE: Before you troubleshoot, record all freeze data and any on-board
snapshot, and review General Troubleshooting Information.
1. Warm up the engine to normal operating
temperature (the radiator fan comes on).
2. Make sure that the transmission is filled to the
proper level, and check for fluid
DTC 41-1x ("x" can be 0 thru 9 or A thru F):
No Signal From the Left Front Impact Sensor
Specia1 Tools Required
SRS inflator simulator 07SAZ-TB4011A
SRS simulator lead L 070AZ-SNAA300
NOTE: Before doing this troubleshooting procedure,
review SRS Precautions and Procedures.
1. Erase the DTC memory.
2. Turn the ignition switch ON (II), and check that the
SRS indicator comes on for
© 2016-2025 Copyright www.hcrv.net
