Honda CR-V: Floor Mats

The floor mats that came with your

The floor mats that came with your vehicle hook over the floor mat anchors. This keeps the floor mats from sliding forward, possibly interfering with the pedals, or backwards, making the front passenger’s weight sensors ineffective.

If you remove a floor mat, make sure to re-anchor it when you put it back in your vehicle.

If you use a non-Honda floor mat, make sure it fits properly and that it can be used with the floormat anchors. Do not put additional floor mats on top of the anchored mats.

READ NEXT:

 Audio Antenna

Your vehicle is equipped with an antenna at the rear of the roof . Bef ore using a ‘‘drive-through’’ car wash, remove the antenna by unscrewing it by hand. This prevents the antenna

 Dust and Pollen Filter

This filter removes the dust and pollen that is brought in fromthe outside through the heating and cooling system/climate control system. Have your dealer replace this filter when this serv

 Wiper Blades

Check the condition of the wiper blades at least every six months. Replace them if you find signs of cracking in the rubber, areas that are getting hard, or if they leave streaks and unwiped

SEE MORE:

 Towing Equipment and Accessories

Towing can require a variety of equipment, depending on the size of your trailer, how it will be used, how much load you are towing, and where you tow. Discuss your needs with your trailer sales or rental agency, and follow the guidelines in this section. Also make sure that all equip

 VTC Actuator, Exhaust Camshaft Sprocket Replacement

Removal 1. Remove the cam chain. 2. Hold the camshaft with an open-end wrench, then loosen the variable valve timing control (VTC) actuator mounting bolt and exhaust camshaft sprocket mounting bolt. 3. If the VTC actuator will be reused, do these steps. Remove the intake camshaft, and seal the

© 2016-2025 Copyright www.hcrv.net