Honda CR-V: Relay and Control Unit Locations

Honda CR-V (2006–2011) Service Manual / Body Electrical / Relay and Control Unit Locations

Engine Compartment

Honda CR-V. Relay and Control Unit Locations

Dashboard

Honda CR-V. Relay and Control Unit Locations

Honda CR-V. Relay and Control Unit Locations

Honda CR-V. Relay and Control Unit Locations

Driver's Door

Honda CR-V. Relay and Control Unit Locations

Seat

Honda CR-V. Relay and Control Unit Locations

READ NEXT:

 Connectors and Harnesses

Connector Index Identification numbers have been assigned to in-line connectors, junction connectors, and terminals. The number is preceded by the letter ºC" for connectors "G" for ground terminals

 Under-hood/dash Fuse/Relay Box

Under-hood Fuse/Relay Box Removal and Installation Removal 1. Make sure you have the anti-theft codes for the audio and navigation system. If equipped with XM radio, write down the XM radio presets.

 Battery

WARNING A battery can explode if you do not follow the proper procedure, causing serious injury to anyone nearby. Follow all procedures carefully and keep sparks and open flames away from the battery.

SEE MORE:

 Trim Removal/Installation

Trim Removal/Installation-Door Areas Special Tools Required KTC trim tool set SOJATP2014 * * Available through the American Honda Tool and Equipment Program; call 888-424-6857 SRS components are located in this area. Review the SRS component locations and the precautions and procedures before doin

 DTC P0325: Knock Sensor Circuit Malfunction

NOTE: Before you troubleshoot, record all freeze data and any on-board snapshot, and review the general troubleshooting information. 1. Turn the ignition switch ON (II). 2. Clear the DTC with the HDS. 3. Start the engine. Hold the engine speed between 3,000 rpm without load (in Park or neutral) u

© 2016-2025 Copyright www.hcrv.net