Honda CR-V: Relay and Control Unit Locations
Honda CR-V (2006–2011) Service Manual / Body Electrical / Relay and Control Unit
Locations
Engine Compartment
- VSA MODULATOR-CONTROL UNIT
- AUXILIARY UNDER-HOOD RELAY BOX
- POWER MIRROR DEFOGGER RELAY
- PCM
- RADIATOR FAN RELAY
- ELECTRONIC THROTTLE CONTROL SYSTEM (ETCS) CONTROL RELAY
- ELD UNIT
- PGM-FI MAIN RELAY 1 (FI MAIN)
- UNDER-HOOD FUSE/RELAY BOX
- FAN CONTROL RELAY
- BLOWER MOTOR RELAY
- REAR WINDOW WIPER MOTOR RELAY
- PGM-FI SUBRELAY
- REAR WINDOW DEFOGGER RELAY
- IGNITION COIL RELAY
- A/C COMPRESSOR CLUTCH RELAY
Dashboard
- GAUGE CONTROL MODULE
- XM RECEIVER (With XM radio)
- CARGO AREA ACCESSORY POWER SOCKET RELAY
- CONSOLE ACCESSORY POWER SOCKET RELAY
- FRONT ACCESSORY POWER SOCKET RELAY
- TPMS CONTROL UNIT
- NAVIGATION DISPLAY UNIT or AUDIO UNIT (Without navigation system)
- IMMOBILIZER-KEYLESS CONTROL UNIT (Built-in receiver)
- HVAC CONTROL UNIT
- SRS UNIT
Driver's Door
- POWER WINDOW MASTER SWITCH (Has built-in control unit)
- MOONROOF CONTROL UNIT/MOTOR
Seat
- DRIVER'S SEAT
- DRIVER'S SEAT HEATER
HIGH RELAY (4P)
DRIVER'S SEAT HEATER LOW RELAY (5P) - FRONT PASSENGER'S SEAT
- FRONT PASSENGER'S SEAT
HEATER HIGH RELAY (4P)
FRONT PASSENGER'S SEAT HEATER LOW RELAY (5P)
READ NEXT:
Connectors and Harnesses
Connector Index
Identification numbers have been assigned to in-line connectors, junction
connectors, and terminals. The number is preceded by the letter ºC" for
connectors "G" for ground terminals
Under-hood/dash Fuse/Relay Box
Under-hood Fuse/Relay Box
Removal and Installation
Removal
1. Make sure you have the anti-theft codes for the
audio and navigation system. If equipped with XM
radio, write down the XM radio presets.
Battery
WARNING
A battery can explode if you do not follow the
proper procedure, causing serious injury to anyone
nearby. Follow all procedures carefully and keep
sparks and open flames away from the battery.
SEE MORE:
Automatic Transmission Fluid
Check the fluid level with the engine
at normal operating temperature.
1. Park the vehicle on level ground.
Start the engine, let it run until the
radiator fan comes on, then shut
off the engine. For accurate
results, wait about 60 seconds (but
no longer than 90 seconds) before
doing
DTC P0101: MAF Sensor Range/Performance Problem
NOTE:
Before you troubleshoot, record all freeze data and
any on-board snapshot, and review the general
troubleshooting information.
If DTC P1128, P1129, P2228, and/or P2229 are stored
at the same time as DTC P0101, troubleshoot those
DTCs first, then recheck for DTC P0101.
1. Check for poor
© 2016-2025 Copyright www.hcrv.net
