Honda CR-V: Relay and Control Unit Locations

Honda CR-V (2006–2011) Service Manual / Body Electrical / Relay and Control Unit Locations

Engine Compartment

Honda CR-V. Relay and Control Unit Locations

Dashboard

Honda CR-V. Relay and Control Unit Locations

Honda CR-V. Relay and Control Unit Locations

Honda CR-V. Relay and Control Unit Locations

Driver's Door

Honda CR-V. Relay and Control Unit Locations

Seat

Honda CR-V. Relay and Control Unit Locations

READ NEXT:

 Connectors and Harnesses

Connector Index Identification numbers have been assigned to in-line connectors, junction connectors, and terminals. The number is preceded by the letter ºC" for connectors "G" for ground terminals

 Under-hood/dash Fuse/Relay Box

Under-hood Fuse/Relay Box Removal and Installation Removal 1. Make sure you have the anti-theft codes for the audio and navigation system. If equipped with XM radio, write down the XM radio presets.

 Battery

WARNING A battery can explode if you do not follow the proper procedure, causing serious injury to anyone nearby. Follow all procedures carefully and keep sparks and open flames away from the battery.

SEE MORE:

 Opening and Closing the Hood

1. Park the vehicle, and set the parking brake. Pull the hood release handle located under the lower left corner of the dashboard. The hood will pop up slightly. 2. Reach in between the hood and the front grille with your fingers. The hood latch handle is above the ‘‘H’’ log

 DTC 12, 14, 16, 18: Wheel Sensor (Electrical Noise/Intermittent Interruption)

NOTE: If the ABS and other indicators come on because of electrical noise, the indicators will go off when you test-drive the vehicle at 10 mph (15 km/h) or more and noise is gone. An incorrectly installed wheel bearing can cause one of these DTCs. 1. Turn the ignition switch OFF. 2. Check

© 2016-2025 Copyright www.hcrv.net