Honda CR-V: Fan Controls
Component Location Index
- RADIATOR FAN RELAY
- A/C CONDENSER FAN RELAY
- FAN CONTROL RELAY

-
A/C CONDENSER FAN ASSEMBLY
-
RADIATOR FAN ASSEMBLY
-
ENGINE COOLANT TEMPERATURE
(ECT) SENSOR 1
-
ENGINE COOLANT TEMPERATURE
(ECT) SENSOR 2
Symptom Troubleshooting Index

Circuit Diagram

Radiator Fan High Speed Circuit Troubleshooting
1. Remove the fan control relay from the under-hood
fuse/relay box, and test it.
Is the relay OK?
YES-Go to step 2.
NO-Replace the fan control relay.
2. Measure the voltage between the fan control relay
5P socket terminal No. 5 and body ground.

Is there battery voltage?
YES-Go to step 3.
NO-Replace the under-hood fuse/relay box.
3. Check for continuity between the fan control relay
5P socket terminal No.2 and body ground.

Is there continuity? YES-Replace the under-hood fuse/relay box.
NO-Repair open in the wire between the fan
control relay 5P socket terminal No.2 and body
ground. If the wire is OK, check for poor ground at
G301.
READ NEXT:
Special Tools
Fuel Sender Wrench
Fuel Pressure Gauge Attachment Set
Vacuum/Pressure Gauge, 0-4 in.Hg
Pressure Gauge Adapter
Oil Pressure Hose
A/T Pressure Hose
A/T Low Pressure
Intermittent Failures
The term "intermittent failure" means a system may
have had a failure, but it checks OK now. If the
malfunction indicator lamp (MIL) on the dash does not
come on, check for poor
SEE MORE:
1. Check for sound in each mode (AM, FM, XM, and
disc).
Is there sound from the speakers, and is the sound quality normal in each mode?
YES-Intermittent failure. The system is OK at this time. Check for loose
connections at the navigation unit, audio unit, amplifier, and each speaker.
NO-Speaker
1. MIST
2. OFF
3. INT Intermittent
4. LO Low speed
5. HI High speed
6. Windshield washers
Push the right lever up or down to
select a position.
MIST - The wipers run at high
speed until you release the lever.
OFF - The wipers are not activated.
INT - The wipers operate every
few s
© 2016-2025 Copyright www.hcrv.net
