Honda CR-V manuals

Honda CR-V: Accessory Power Sockets

Honda CR-V (2006–2011) Owner's Manual / Instruments and Controls / Interior Convenience Items / Accessory Power Sockets

Your vehicle has two or three

Your vehicle has two or three accessory power sockets depending on the model.

To use an accessory power socket,

To use an accessory power socket, the ignition switch must be in the ACCESSORY (I) or ON (II) position.

Each socket is intended to supply power for 12 volt DC accessories that are rated 120 watts or less (10 amps).

None of the sockets will power an

None of the sockets will power an automotive type cigarette lighter element.

Make sure to put the socket cover

Make sure to put the socket cover back in place to prevent any small foreign objects from getting into the socket.

READ NEXT:

 Console Compartment

EX-L model Push the release knob to open or close the console compartment, slide the lid rearward.

 Coat Hook

To use a coat hook, slide it out slightly, then pull it down. Make sure the coat hook is folded up when you are not using it. This hook is not designed for large or heavy items.

 Seat Under Tray

If equipped Your vehicle has a seat under tray located under the front passenger seat. Use the tray by pulling on the front center edge of the tray.

SEE MORE:

 DTC 86: F-CAN Communication

1. Turn the ignition switch ON (II). 2. Clear the DTC with the HDS. 3. Turn the ignition switch OFF. 4. Start the engine. 5. Wait at least 5 seconds. 6. Check for DTCs with the HDS. Is DTC 86 indicated? YES-Go to step 7. NO-Intermittent failure, the system is OK at this time. Check for a loos

 Entry Lights Control System

Component Location Index With moonroof INDIVIDUAL MAP LIGHTS IGNITION KEY SWITCH IGNITION KEY LIGHT CEILING LIGHT CARGO AREA LIGHT RIGHT REAR DOOR SWITCH FRONT PASSENGER'S DOOR SWITCH LEFT REAR DOOR SWITCH DRIVER'S DOOR SWITCH DRIVER'S DOOR LOCK KNOB SWITCH MICU (Built into the under

© 2016-2025 Copyright www.hcrv.net