Honda CR-V: Relay and Control Unit Locations

Honda CR-V (2006–2011) Service Manual / Body Electrical / Relay and Control Unit Locations

Engine Compartment

Honda CR-V. Relay and Control Unit Locations

Dashboard

Honda CR-V. Relay and Control Unit Locations

Honda CR-V. Relay and Control Unit Locations

Honda CR-V. Relay and Control Unit Locations

Driver's Door

Honda CR-V. Relay and Control Unit Locations

Seat

Honda CR-V. Relay and Control Unit Locations

READ NEXT:

 Connectors and Harnesses

Connector Index Identification numbers have been assigned to in-line connectors, junction connectors, and terminals. The number is preceded by the letter ºC" for connectors "G" for ground terminals

 Under-hood/dash Fuse/Relay Box

Under-hood Fuse/Relay Box Removal and Installation Removal 1. Make sure you have the anti-theft codes for the audio and navigation system. If equipped with XM radio, write down the XM radio presets.

 Battery

WARNING A battery can explode if you do not follow the proper procedure, causing serious injury to anyone nearby. Follow all procedures carefully and keep sparks and open flames away from the battery.

SEE MORE:

 Glass

Component Location Index WINDSHIELD MOLDING MOLDING UPPER SEAL UPPER RUBBER DAM CLIP, 2 WINDSHIELD SIDE TRIM SIDE RUBBER DAM WINDSHIELD RETAINER,8 QUARTER GLASS MOLDING CLIP, 1 CLIP, 2 QUARTER GLASS ULEV STICKER FRONT SEAL UPPER RUBBER DAM UPPER FASTENER 2 FASTENER 2 LOW

 Cylinder Head Installation

1. Install a new coolant separator in the engine block whenever the engine block is replaced. 2. Clean the cylinder head and block surface. 3. Install the new cylinder head gasket (A) and dowel pins (B) on the engine block. Always use a new cylinder head gasket. Set the crankshaft to top dead cen

© 2016-2025 Copyright www.hcrv.net