Honda CR-V: Dehumidify the Interior

Air conditioning, as it cools, removes moisture from the air.When used in combination with the heater, it makes the interior warm and dry and can prevent the windows from fogging up.

1. Turn the fan on.

2. Turn on the air conditioning.

3. Select 4. Adjust the temperature to your and fresh air mode.

4. Adjust the temperature to your preference.

This setting is suitable for all driving conditions whenever the outside temperature is above 32°F (0°C).

READ NEXT:

 To Defog and Defrost

To remove fog from the inside of the windows: 1. Set the fan to the desired speed, or high for faster defrosting. 2. Select . The system automatically switches to fresh air mode and turns o

 To Remove Exterior Frost or Ice Fromthe Windows

1. Select . The system automatically switches to fresh air mode and turns on the A/C. The A/C indicator does not come on if it was off to start with. 2. Select . 3. Set the fan and temperat

 To Turn Everything Off

Turning the fan speed control dial all the way to the left shuts the system off. Keep the system off for short periods only. To keep stale air and mustiness from collecting, you should have

SEE MORE:

 Cylinder Head Installation

1. Install a new coolant separator in the engine block whenever the engine block is replaced. 2. Clean the cylinder head and block surface. 3. Install the new cylinder head gasket (A) and dowel pins (B) on the engine block. Always use a new cylinder head gasket. Set the crankshaft to top dead cen

 Dual Pump System Function Test

Starting and accelerating in forward gears (4WD mode) NOTE: Do not test repeatedly or the fluid will overheat. 1. Lift up the vehicle so all four wheels are off the ground. 2. Make a mark (A) on either No.1 or No.2 propeller shaft (B). 3. Start the engine, and let it run until it warms up (the ra

© 2016-2025 Copyright www.hcrv.net