Honda CR-V manuals

Honda CR-V: To Change or Select Files

Honda CR-V (2006–2011) Owner's Manual / Features / Playing a USB Flash Memory Device (EX-L model with navigation system) / To Change or Select Files

Use the SKIP button while a USB flash memory device is playing to change files.

SKIP - Each time you press and release skips forward to the beginning of the (preset 6), the player skips forward to the beginning of the next file. Press and release to  (preset 5), to skip backward to the beginning of the current file.

Press it again to skip to the beginning of the previous file.

FF/REW - To move rapidly within a file, press and hold or (preset 3). (preset 4) or FOLDER SELECTION - To (preset 3).

FOLDER SELECTION - To select a different folder, press either side of the TUNE bar. Press the and press the side to skip to the side to skip to the next folder, and press the beginning of the previous folder. side to skip to the beginning of the previous folder.

READ NEXT:

 Using a Track List

You can also select a file directly from a track list on the audio display. Press the AUDIO button to show the audio display, then touch the Track List icon. The track list menu appears on

 To Stop Playing a USB Flash Memory Device

To play the radio, press the AM/FM button or touch the FM1, FM2, AM, XM1, or XM2 icon. Touch the CD icon to switch to the disc mode (if a disc is loaded). Each time you press the CD/XM butto

 Disconnecting a USB Flash Memory Device

You can disconnect the USB flash memory device at any time even if the USB mode is selected on the audio system. Always follow the USB flash memory device’s instructions when you remove it

SEE MORE:

 Phone Setup

This command group is available for paired cell phones. Phone pairing tips You cannot pair your phone while the vehicle is moving. Your phone must be in discovery or search mode to pair. Refer to your phone’s manual. Up to six phones can be paired. Your phone’s battery may drain f

 Cylinder Head Installation

1. Install a new coolant separator in the engine block whenever the engine block is replaced. 2. Clean the cylinder head and block surface. 3. Install the new cylinder head gasket (A) and dowel pins (B) on the engine block. Always use a new cylinder head gasket. Set the crankshaft to top dead cen

© 2016-2026 Copyright www.hcrv.net