Honda CR-V: Accelerating and Braking

For better traction on all surfaces, accelerate slowly and gradually build up speed. If you try to start too fast on wet soil, mud, snow, or ice, you might not have enough traction to get underway, and you may dig yourself a hole. Starting with the shift lever in second (2) gear will help you have a smoother start on snow or ice.

Keep in mind that you will usually need more time and distance to brake to a stop on unpaved surfaces.

Avoid hard braking. Do not ‘‘pump’’ the brakes; let the anti-lock braking system pump them for you.

READ NEXT:

 Avoiding Obstacles

Debris in the road can damage your suspension or other components. Because your vehicle has a high center of gravity, driving over a large obstacle, or allowing a wheel to drop into a deep ho

 Driving on Slopes

If you can’t clearly see all conditions or obstacles on a slope, walk the slope before you drive on it. If you have any doubt whether or not you can safely drive on the slope, don’t do i

 Crossing a Stream

Avoid driving through deep water. If you encounter water in your route (a small stream or large puddle, for example), evaluate it carefully before going ahead. Make sure it is shallow, flowi

SEE MORE:

 APP Sensor Signal Inspection

NOTE: This procedure checks the APP sensor in its fully closed position. In any other position, the APP sensor stores DTCs which are covered in other troubleshooting procedures. Check for Temporary DTCs or DTCs with the HDS before doing this procedure. If any DTCs are indicated, troubleshoot

 Door Lock

Door Lock Actuator Test Driver's Door and Left Rear Door 1. Remove the door panel. Front Rear 2. Disconnect the 10P connector (A) from the actuator (B). NOTE: The illustration shows the driver's door. 3. Check the actuator operation by connecting power and ground according to the table. To

© 2016-2026 Copyright www.hcrv.net