Honda CR-V manuals

Honda CR-V: Windshield Wiper

Honda CR-V (2006–2011) Owner's Manual / Instruments and Controls / Windshield Wipers and Washers / Windshield Wiper

1. MIST

1. MIST
2. OFF
3. INT Intermittent
4. LO Low speed
5. HI High speed
6. Windshield washers

Push the right lever up or down to select a position.

MIST - The wipers run at high speed until you release the lever.

OFF - The wipers are not activated.

INT - The wipers operate every few seconds. At low speed and high speed, the wipers run continuously.

On all models except LX

Vary the delay by turning the adjustment ring. If you turn it to the shortest delay (wipers change to low speed position), the wipers change to low speed operation when the vehicle speed exceeds 12 mph (20 km/h).

The length of the wiper interval is varied automatically according to the vehicle’s speed.

LO - The wipers run at low speed.

HI - The wipers run at high speed.

READ NEXT:

 WindshieldWashers

Pull the wiper control lever toward you, and hold it. The washers spray until you release the lever. The wipers run at low speed, then complete one more sweep after you release the lever.

 Rear Window Wiper and Washer

1. OFF When you turn the wiper switch to the ‘‘OFF’’ position, the wiper will return to its parked position. 2. Rotate the switch clockwise to turn the rear window wiper ON. The

 Turn Signal and Headlights

1. Turn Signal 2. OFF 3. Parking and interior lights 4. AUTO 5. Headlights on 6. High Beams 7. Flash high beams *: If equipped Turn Signal - Push down on the lever to signal a left turn

SEE MORE:

 DTC P0300: Random Misfire and Any Combination of the Following

DTC P0301: No.1 Cylinder Misfire Detected DTC P0302: No.2 Cylinder Misfire Detected DTC P0303: No.3 Cylinder Misfire Detected DTC P0304: No.4 Cylinder Misfire Detected Special Tools Required Pressure gauge adapter 07NAJ-P07010A A/T low pressure gauge w/panel 07406-0070301 A/T pressure hose 07406

 Symptom Troubleshooting

SRS indicator does not come on 1. Connect the HDS to the DLC. 2. Turn the ignition switch ON (II). 3. Make sure the HDS communicates with the vehicle and the SRS unit. If it does not communicate, troubleshoot the DLC circuit. 4. Check for PGM-FI, Body Electrical, and SRS DTCs with the HDS. Are

© 2016-2025 Copyright www.hcrv.net