Honda CR-V: Selecting a Child Seat
When buying a child seat, you need to choose either a conventional child seat, or one designed for use with the Lower Anchors and Tethers for CHildren (LATCH) system.
Conventional child seats must be secured to a vehicle with a seat belt, whereas LATCH-compatible seats are secured by attaching the seat to hardware built into each rear seating position in the back seat.
Since LATCH-compatible child seats are easier to install and reduce the possibility of improper installation, we recommend selecting this style.
In seating positions and vehicles not equipped with LATCH, a LATCHcompatible child seat can be installed using a seat belt.
Whatever type of seat you choose, to provide proper protection, a child seat should meet three requirements:
1. The child seat should meet Federal Motor Vehicle Safety Standard 213 or Canadian Motor Vehicle Safety Standard 213.
Look for FMVSS 213 or CMVSS 213 on the box.
2. The child seat should be of the proper type and size to fit the child.
Rear-facing for infants, forwardfacing for small children.
3. The child seat should fit the vehicle seating position (or positions) where it will be used.
Before purchasing a conventional child seat, or using a previously purchased one, we recommend that you test the seat in the specific vehicle seating position or positions where the seat will be used.
READ NEXT:
Installing a Child Seat
After selecting a proper child seat
and a good place to install the seat,
there are three main steps in
installing the seat:
1. Properly secure the child seat to
the vehicle. All child seats
Installing a Child Seat with LATCH
Your vehicle is equipped with
LATCH (Lower Anchors and
Tethers for CHildren) at the rear
seats to secure a child seat in any
seating position: one in each outer
seating position, or one in t
Installing a Child Seat with a Lap/Shoulder Belt
When not using the LATCH system,
all child seats must be secured to the
vehicle with the lap part of a lap/
shoulder belt.
In addition, the lap/shoulder belts in
all seating positions except
SEE MORE:
DTC P0107: Manifold Absolute Pressure
(MAP) Sensor Circuit Low Voltage Input
NOTE: Before you troubleshoot, record all freeze data and any on-board
snapshot, and review General Troubleshooting Information.
1. Clear the DTC with the HDS.
2. Turn the ignition switch OFF, then turn it ON (II)
again.
3. Check whether DTC P0107 is indicated in the DTCs/
Freeze Data in PGM-FI M
Carrying Cargo in the Passenger Compartment
Store or secure all items that could
be thrown around and hurt
someone during a crash.
Be sure items placed on the floor
behind the front seats cannot roll
underneath and interfere with the
proper operation of the seats, the
sensors under the seats, or the
driver’s ability to operat
