Honda CR-V: WindshieldWashers

Pull the wiper control lever toward you, and hold it. The washers spray until you release the lever. The wipers run at low speed, then complete one more sweep after you release the lever.

READ NEXT:

 Rear Window Wiper and Washer

1. OFF When you turn the wiper switch to the ‘‘OFF’’ position, the wiper will return to its parked position. 2. Rotate the switch clockwise to turn the rear window wiper ON. The

 Turn Signal and Headlights

1. Turn Signal 2. OFF 3. Parking and interior lights 4. AUTO 5. Headlights on 6. High Beams 7. Flash high beams *: If equipped Turn Signal - Push down on the lever to signal a left turn

 Daytime Running Lights

With the headlight switch in the off or position, the high beam headlights and the high beam indicator come on with reduced brightness when you turn the ignition switch to the ON (II)

SEE MORE:

 EGR System

Component Location Index EXHAUST GAS RECIRCULATION (EGR) VALVE POWERTRAIN CONTROL MODULE (PCM) EXHAUST GAS RECIRCULATION (EGR) PLATE DTC Troubleshooting DTC P0401: EGR Insufficient Flow NOTE: Before you troubleshoot, record all freeze data and any on-board snapshot, and review the genera

 Oil Pan Removal

1. If the engine is already out of the vehicle, go to step 20. 2. Raise the vehicle on the lift to full height. 3. Drain the engine oil. 4. Remove the front wheels. 5. Remove the splash shield (see step 21). 6. Disconnect the air fuel ratio (A/F) sensor connector and secondary heated oxygen sen

© 2016-2025 Copyright www.hcrv.net