Honda CR-V: Check Fuel Cap Message

Your vehicle’s onboard diagnostic

Your vehicle’s onboard diagnostic system will detect a loose or missing fuel fill cap as an evaporative system leak. The first time a leak is detected a ‘‘CHECK FUEL CAP’’ message appears on the information display.

Turn the engine off, and confirm the fuel fill cap is installed. If it is, loosen it, then retighten it until it clicks at least once. The message should go off after several days of normal driving once you tighten or replace the fuel fill cap. To scroll to another display, press the select/reset knob.

The ‘‘CHECK FUEL CAP’’ message will appear each time you restart the engine until the system turns the message off.

If the system still detects a leak in your vehicle’s evaporative emissions system, the malfunction indicator lamp (MIL) comes on. If the fuel fill cap was not already tightened, turn the engine off, and check or retighten the fuel fill cap until it clicks at least once. The MIL should go off after several days of normal driving once the cap is tightened or replaced. If the MIL does not go off, have your vehicle inspected by a dealer. For more information.

READ NEXT:

 Opening and Closing the Hood

1. Park the vehicle, and set the parking brake. Pull the hood release handle located under the lower left corner of the dashboard. The hood will pop up slightly. 2. Reach in between the ho

 Oil Check

Wait a few minutes after turning the engine off before you check the oil. 1. Remove the dipstick (orange handle). 2. Wipe off the dipstick with a clean cloth or paper towel. 3. Insert the d

 Engine Coolant Check

Look at the coolant level in the radiator reserve tank. Make sure it is between the MAX and MIN lines. If it is below the MIN line, see Adding Engine Coolant on page for information on add

SEE MORE:

 Horns

Component Location Index HORN HORN SWITCH HORN RELAY CIRCUIT (Built into the MICU) CABLE REEL UNDER-DASH FUSE/RELAY BOX Circuit Diagram Horn Switch Test 1. Remove the steering column covers. 2. Disconnect the dashboard wire harness 20P connector (A) from the cable reel (B). 3. Usin

 Advice for Pregnant Women

If you are pregnant, the best way to protect yourself and your unborn child when driving or riding in a vehicle is to always wear a seat belt, and keep the lap part of the belt as low as possible across the hips. When driving, remember to sit upright and adjust the seat as far bac

© 2016-2025 Copyright www.hcrv.net