Honda CR-V: WindshieldWashers

Pull the wiper control lever toward you, and hold it. The washers spray until you release the lever. The wipers run at low speed, then complete one more sweep after you release the lever.

READ NEXT:

 Rear Window Wiper and Washer

1. OFF When you turn the wiper switch to the ‘‘OFF’’ position, the wiper will return to its parked position. 2. Rotate the switch clockwise to turn the rear window wiper ON. The

 Turn Signal and Headlights

1. Turn Signal 2. OFF 3. Parking and interior lights 4. AUTO 5. Headlights on 6. High Beams 7. Flash high beams *: If equipped Turn Signal - Push down on the lever to signal a left turn

 Daytime Running Lights

With the headlight switch in the off or position, the high beam headlights and the high beam indicator come on with reduced brightness when you turn the ignition switch to the ON (II)

SEE MORE:

 Radiator and A/C Condenser Fan Low Speed Circuit Troubleshooting

NOTE: Do not use this troubleshooting procedure if the A/C compressor is inoperative. Refer to the symptom troubleshooting index. Before doing symptom troubleshooting, check for powertrain DTCs. 1. Check the No.7 (20 A) fuse in the under-hood fuse/relay box, and the No. 36 (10 A) fuse in the

 Knuckle/Hub/Wheel Bearing Replacement

Exploded View Special Tools Required Hub dis/assembly tool 07GAF-SD40100 Ball joint remover, 32 mm 07MAC-SL0A102 Ball joint remover, 28 mm 07MAC-SL0A202 Ball joint thread protector, 14 mm 071AF-S3VA000 Attachment, 72 x 75 mm 077 46-0010600 Driver 077 49-0010000 Attachment, 96 mm 07948-SB001

© 2016-2025 Copyright www.hcrv.net